ISP1562BEGE ST-Ericsson Inc, ISP1562BEGE Datasheet - Page 32

• Manufacturer Part Number: ISP1562BEGE
• Description: IC USB PCI HOST CTRLR 100-LQFP
• Manufacturer: ST-Ericsson Inc

Specifications of ISP1562BEGE

• Applications: USB Host/Function Processor
• Interface: EHCI Interface
• Voltage - Supply: 3 V ~ 3.6 V
• Package / Case: 100-LQFP
• Mounting Type: Surface Mount
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-3157; ISP1562BE

NXP Semiconductors
10. Power management
ISP1562_2
Product data sheet
10.1 PCI bus power states
9.3 Information loading from EEPROM
The slave address that the ISP1562 uses to access the EEPROM is 101 0000b. Page
mode addressing is not supported. Therefore, pins A0, A1 and A2 of the EEPROM must
be connected to ground (logic 0).
Figure 6
default values of device ID, vendor ID, subsystem VID and subsystem DID assigned to
NXP Semiconductors by PCI-SIG will be loaded. For default values, see
The PCI bus can be characterized by one of the four power management states: B0, B1,
B2 and B3.
B0 state (PCI clock = 33 MHz, PCI bus power = on) — This corresponds to the bus
being fully operational.
B1 state (PCI clock = intermittent clock operation mode, PCI bus power = on) —
When a PCI bus is in B1, PCI V
transactions, however, are allowed to take place on the bus. The B1 state indicates a
perpetual idle state on the PCI bus.
B2 state (PCI clock = stop, PCI bus power = on) — PCI V
but the clock is stopped and held in the LOW state.
B3 state (PCI clock = stop, PCI bus power = off) — PCI V
devices on the PCI bus segment.
Fig 6. Information loading from EEPROM
address
L = LOW; H = HIGH.
shows the content of the EEPROM memory. If the EEPROM is not present, the
7
5
6
0
1
2
3
4
Rev. 02 — 1 March 2007
CC
is still applied to all devices on the bus. No bus
subsystem vendor ID (L)
subsystem vendor ID (H)
subsystem device ID (L) - OHCI
subsystem device ID (H) - OHCI
subsystem device ID (L) - EHCI
subsystem device ID (H) - EHCI
reserved - FFh
signature
15h - loads subsystem vendor ID, device ID
1Ah - loads default values defined by NXP Semiconductors
HS USB PCI Host Controller
CC
CC
is still applied on the bus,
is removed from all
© NXP B.V. 2007. All rights reserved.
ISP1562
Table
004aaa930
3.
31 of 93