ZMOTIONS200ZCOG Zilog, ZMOTIONS200ZCOG Datasheet - Page 15

• Manufacturer Part Number: ZMOTIONS200ZCOG
• Description: KIT DEV ZMOTION MODULE
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONS200ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: -
• Interface: USB/Serial
• Sensitivity: -
• Voltage - Supply: -
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZMOT1AHH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 269-4823

Signal Descriptions
PS028801-0311
Signal
Mnemonic
General-Purpose I/O Ports A–D
PA[7:0]
PB[5:0]
PC[7:0]
PD[0]
UART Controllers
TXD0
RXD0
CTS0
DE
Timers
T0OUT/T1OUT
T0OUT/T1OUT
T0IN/T1IN
Comparator
CINP/CINN
COUT
Analog
ANA[7:0]
V
REF
Table 2 describes the Z8FS021 MCU signals. Signal availability is package dependent.
See the
I/O
I/O
I/O
I/O
I/O
O
O
O
O
O
O
Pin Configuration
I
I
I
I
I
Table 2. Z8FS021 MCU Signal Descriptions
Description
Port A. These pins are used for general-purpose I/O.
Port B. These pins are used for general-purpose I/O.
Port C. These pins are used for general-purpose I/O.
Port D. This pin is used for general-purpose output only.
Transmit Data. This signal is the transmit output from the UART and IrDA.
Receive Data. This signal is the receive input for the UART and IrDA.
Clear To Send. This signal is the flow control input for the UART.
Driver Enable. This signal allows automatic control of external RS-485
drivers. It is approximately the inverse of the Transmit Empty (TXE) bit in
the UART Status 0 Register. The DE signal can be used to ensure that the
external RS-485 driver is enabled when data is transmitted by the UART.
Timer Output 0–1. These signals are outputs from the timers.
Timer Complement Output 0–1. These signals are output from the timers in
PWM Dual Output mode.
Timer Input 0–1. These signals are used as the capture, gating and counter
inputs.
Comparator Inputs. These signals are the positive and negative inputs to
the comparator.
Comparator Output.
Analog Port. These signals are used as inputs to the analog-to-digital
converter (ADC).
Analog-to-digital converter reference voltage input, or buffered output for
internal reference.
section on page 5 for signal availability multiplexing.
ZMOTION
Product Specification
™
Intrusion Detection
Signal Descriptions
8