ZMOTIONS200ZCOG Zilog, ZMOTIONS200ZCOG Datasheet - Page 67

• Manufacturer Part Number: ZMOTIONS200ZCOG
• Description: KIT DEV ZMOTION MODULE
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONS200ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: -
• Interface: USB/Serial
• Sensitivity: -
• Voltage - Supply: -
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZMOT1AHH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 269-4823

Appendix B. PIR Engine Initialization and Control
PS028801-0311
The application software must execute an initialization procedure to enable the PIR
Engine. Once the PIR Engine is enabled, it runs in the background from the ADC inter-
rupt. Every ADC conversion generates an interrupt and the PIR Engine performs its func-
tions during this time. The user application code runs in the foreground and monitors the
status through the API and performs any other functions required for the application.
The PIR Engine also requires a one-second tick to perform several house-keeping opera-
tions and to keep track of its sampling rate. This one-second time base must be provided
by the user application through Status/Control Register 1 (Engine Timer Tick). This bit
should be set to 1 at the rate of once per second by the application software to provide the
Engine with a one-second time base. The accuracy of this timing is not critical, but should
be within +/– 10%.
There are two basic modes in which the PIR Engine operates: Normal Scan Rate mode and
Low Scan Rate mode. See the description of the PIR Scan Rate bit in the
trol Register 1
The PIR Engine runs in the background from the ADC interrupt (initiated by the applica-
tion). Engine processing is done during the ADC interrupt. Therefore, CPU loading is
based on the sample rate of the ADC. To ensure a consistent sample rate, the Engine must
know the MCU operating (system clock) frequency. It uses the Flash Frequency Control
Registers to determine the operating frequency, which must be initialized prior to starting
the Engine.
The Flash Frequency High (FFREQH) and Flash Frequency Low Byte (FFREQL) regis-
ters combine to form a 16-bit value FFREQ primarily to control timing for Flash program
and erase functions. This value is also used by the PIR Software Engine to calculate the
required sample rate of the ADC and other functions. The 16-bit value for FFREQ is the
System Clock Frequency in KHz and is calculated using the following equation:
FFREQ[15:0] = {FFREQH[7:0],FFREQL[7:0]} = (System Clock Frequency) / 1000
The process for initializing the PIR Engine is common to both Normal Scan Rate and Low
Scan Rate modes. The sequence goes as follows:
1. Set up the API control registers (standard and advanced).
2. Initialize the FFREQH and FFREQL registers with the MCU clock frequency.
3. Write the PIR Enable Pattern to the PIR Enable Register.
4. Call the PIR Init.
5. Initialize any application-specific I/Os and peripherals.
6. Enable interrupts.
7. Ensure that the PIR Sensor Stable bit (PIR_SC0:0) is set.
8. Continue with the application.
on page 29 for more details.
Appendix B. PIR Engine Initialization and Control
ZMOTION
Product Specification
™
Intrusion Detection
PIR Status/Con-
60