ZMOTIONS200ZCOG Zilog, ZMOTIONS200ZCOG Datasheet - Page 16

• Manufacturer Part Number: ZMOTIONS200ZCOG
• Description: KIT DEV ZMOTION MODULE
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONS200ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: -
• Interface: USB/Serial
• Sensitivity: -
• Voltage - Supply: -
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZMOT1AHH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 269-4823

PS028801-0311
Signal
Mnemonic
Oscillators
XIN
XOUT
Clock Input
CLKIN
LED Drivers
LED
On-Chip Debugger
DBG
Reset
RESET
Power Supply
V
AV
V
AV
DD
SS
DD
SS
Caution:
I/O
I/O
I/O
Table 2. Z8FS021 MCU Signal Descriptions (Continued)
O
O
I
I
I
I
I
I
Description
External Crystal Input. This pin is the input pin to the crystal oscillator. A
crystal can be connected between it and the XOUT pin to form the
oscillator. In addition, this pin is used with external RC networks or external
clock drivers to provide the system clock.
External Crystal Output. This pin is the output of the crystal oscillator. A
crystal can be connected between it and the XIN pin to form the oscillator.
Clock Input Signal. This pin can be used to input a TTL-level signal to be
used as the system clock.
Direct LED drive capability. All port C pins have the capability to drive an
LED without any other external components. These pins have
programmable drive strengths set by the GPIO block.
Debug. This signal is the control and data input and output to and from the
On-Chip Debugger.
The DBG pin is open-drain and requires a pull-up resistor to ensure proper
operation.
RESET. Generates a Reset when asserted (driven Low). Also serves as a
reset indicator; the Z8 Encore! XP forces this pin low when in reset. This pin
is open-drain and features an enabled internal pull-up resistor.
Digital Power Supply.
Analog Power Supply.
Digital Ground.
Analog Ground.
ZMOTION
Product Specification
™
Intrusion Detection
Signal Descriptions
9