ZMOTIONS200ZCOG Zilog, ZMOTIONS200ZCOG Datasheet - Page 20

• Manufacturer Part Number: ZMOTIONS200ZCOG
• Description: KIT DEV ZMOTION MODULE
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONS200ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: -
• Interface: USB/Serial
• Sensitivity: -
• Voltage - Supply: -
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZMOT1AHH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 269-4823

PS028801-0311
Low Power Op Amp
Comparator
UART
Temperature Sensor
LED Drive
WDT
Analog to Digital Signal Conversion
The remainder of this section further describes the differences in application availability
between the 8-pin, 20-pin and 28-pin peripheral sets.
Zilog’s PIR technology requires exclusive access to the ADC peripheral to detect motion.
However, ADC conversions can be requested by the application via the API (PIR Status/
Control Register 3). If it is necessary for the user application to utilize the ADC peripheral
directly, the PIR Engine must first be disabled via the PIR Engine Enable Register in the
API. Motion detection is not possible while the PIR Engine is disabled. When the user
application is finished with the ADC peripheral, it must reenable the PIR Engine.
8-Pin Device.
sensor. Therefore, ANA2 is not available for user applications. Additionally, ANA3 is
used for a second sensor input in Dual Pyro Mode. All other channels are available to the
user application.
20-Pin Device.
sensor. Therefore, ANA2 is not available for user applications. Additionally, ANA3 and
ANA6 are not available because PB3 (ANA3) must be tied directly to PC2 (ANA6/
V
is used for a second sensor input rather than being tied to V
becomes available. All other channels are available to the user application.
REF
). PC2 is configured as V
Not Available
Available to application.
Available to application –
No CTS.
Not available.
—
Available to application.
ADC Channel
Table 3. Peripheral Availability (Continued)
PA3 (ANA2) is reserved as the analog ADC input from the pyroelectric
PB2 (ANA2) is reserved as the analog ADC input from the pyroelectric
0
1
2
3
Yes – used for White Light detection
REF
Available to Application
Only in Single Pyro Mode
output by the PIR Engine. In Dual Pyro Mode, ANA3
Not Available
Available to application.
Available to application.
Not available.
Available to application.
Available to application.
Yes
No
ZMOTION
REF
; ANA6/V
Not Available
Available to application.
Available to application.
Not available.
Available to application.
Available to application.
Product Specification
™
Intrusion Detection
REF
therefore
Peripherals
13