ZMOTIONS200ZCOG Zilog, ZMOTIONS200ZCOG Datasheet - Page 24

• Manufacturer Part Number: ZMOTIONS200ZCOG
• Description: KIT DEV ZMOTION MODULE
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONS200ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: -
• Interface: USB/Serial
• Sensitivity: -
• Voltage - Supply: -
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZMOT1AHH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 269-4823

PS028801-0311
8-Pin Device
20-Pin Device Pin 2 (ANA2) is reserved as the analog ADC input from the pyroelectric sensor. In Single
Pin Availability
Interrupt Controller
Temperature Sensor
Low-Power Operational Amplifier
Non-Volatile Data Storage
General-Purpose Input/Output
No changes or limitations are placed on the interrupt controller functions by the PIR
Engine.
The temperature sensor is not tested or calibrated (trim bits are not available). Therefore,
this peripheral is not available on any of the Z8FS021 devices.
The AMPINP signal is multiplexed with ANA2 which is used for the pyro sensor input.
Therefore, this peripheral is not available on any of the Z8FS021 devices.
There is no dedicated non-volatile data storage on the Z8FS021 devices.
Although most pins on the ZMOTION MCU Series are available to the application, some
pins are dedicated to supporting the functions of the PIR Engine. This section describes
which pins are reserved and which are available to the application. The pins used by the
PIR Engine are automatically configured when the Engine is initialized.
All of the General Purpose I/Os are available except for those used for the PIR circuit. See
Appendix A. Example Application Schematics
Pin 5 (ANA2) is reserved as the analog ADC input from the pyroelectric sensor. Any other
functions multiplexed with Pin 5 (PA3//CTS0, COUT and T1IN) are not available for user
applications.
In Dual Pyro Mode, in which the application uses 2 pyroelectric sensors, Pin 3 (ANA3) is
used as an analog ADC input for a second sensor and is therefore not available for other
functions (T0OUT/V
Pyro Mode, Pin 3 (ANA3) must be externally tied to V
V
In Dual Pyro Mode (supporting 2 pyroelectric sensors), Pin 3 (ANA3) is used for the
second sensor. In this mode the Pin 18 V
other ADC inputs and is therefore available to the application (PC2/ANA6/LED/V
REF
). PC2 will be configured as the V
REF
/CLKIN).
REF
REF
output by the PIR Engine when it is enabled.
signal is not connected externally to any
on page 53 for more information.
ZMOTION
REF
on Pin 18 (PC2/ANA6/LED/
Product Specification
™
Intrusion Detection
Peripherals
REF
).
17