AT32UC3A4128S Atmel Corporation, AT32UC3A4128S Datasheet - Page 106

• Manufacturer Part Number: AT32UC3A4128S
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A4128S

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 2
• Uart: 4
• Sd / Emmc: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: AES
• Sram (kbytes): 128
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

9.2.14.8
32002F–03/2010
Development Status (DS) register
Table 9-11.
This register is used to examine the debug state of the CPU and the cause for entering Debug
Mode. Note that multiple sources may trigger Debug Mode simultaneously, causing more than
one bit to be set. The register is read-only. All bits are dynamic and do not require clearing.
R/W
R/W
R/W
R/W
Bit Number
7:5
4:3
2:0
Development Control Register
Field Name
OVC
EIC
TM
Init. Val.
0
0
0
Description
OVC[2:0] - Overrun Control
OVC controls the action taken if Branch, Data, or
Ownership trace messages are generated while
the Transmit Queue is full. Settings 111 though
100 are reserved.
000 = Generate overrun messages
001 = Delay CPU to avoid BTM and Ownership
Trace overruns
010 = Delay CPU to avoid DTM and Ownership
Trace overruns
011 = Delay CPU to avoid BTM, DTM, and
Ownership Trace overruns
111-100 = Reserved
EIC[1:0] - EVTI Control
The EIC bits control the action performed when
the EVTI pin on the Nexus debug port receives a
high-to-low transition. If trace is enabled, EVTI can
be configured to cause a trace synchronization
message. If Debug Mode is enabled, EVTI can be
configured to cause a breakpoint.
00 = EVTI for program and data trace
synchronization
01 = EVTI for breakpoint generation
10 = No operation
11 = Reserved
TM[2:0] - Trace Mode
The TM bits select which trace modes are
enabled.
000 = No Trace
XX1 = OTM Enabled
X1X = DTM Enabled
1XX = BTM Enabled
If Data or Branch tracing is triggered or stopped by
a watchpoint , the DTM and BTM bits are updated
accordingly.
AVR32
106