SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 49

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

13. Revision History
Table 13-1.
6249HS–ATARM–27-Jul-09
Document
Ref.
6249HS
6249GS
6249FS
6249ES
6249DS
Comments
EBI0_NCS3 restriction added to
Second paragraph in
Overview:
”Features”
Debug Unit (DBGU) updated.
Section 10.4.3
Section 10.4.4 ”Ethernet
Section 6.5 ”Shutdown Logic
Section 5.1 ”Power
Section 5.2, “Power Sequence Requirements removed from datasheet.
New Ordering Code: AT91SAM9263B-CU added to
Section 8.1.2.1 ”BMS = 1, Boot on Embedded
memory”
Section 5.2 ”Power Sequence
Section 10.4.3
Section 10.5.8 ”Multimedia Card
Section 10.5.13 ”Two D Graphics
Table 3-1, ”Signal Description
Table 10-6, ”Multiplexing on PIO Controller
“Features”, SPI: Synchronous Communications feature removed.
Section 5.1 ”Power
Section 5.2 ”Power
Section 10.5.8 ”Multimedia Card
Section 10.5.8 ”Multimedia Card
Section 8.2.1.1 ”External Bus Interface
Section 8.2.1.1 ”External Bus Interface
“Package and
Figure 9-3 ”AT91SAM9263 Power Management Controller Block Diagram” on page
Figure 11-1 ”324-ball TFBGA Package Drawing” on page
Revision History
Pinout”, references to package are “324-TFBGA.
”EBI1”, updated
”EBI1”, System Resource Multiplexing, Ethernet 10/100 MAC limitation on EBI1 updated.
Consumption”, paragraph beginning with “On VDDBU...” updated.
Supplies”, VDDCORE and VDDBU updated.
Supplies”, VDDIO and VDDBU slope alignment described.
Section 5.3 “Programmable I/O Lines Power Supplies” on page 13
10/100MAC”, added to datasheet
Pins”, updated, “SHDN pin is tri state output.......”
List”, Image Sensor Interface, ISI_MCK is provided by PCK3.
Requirements”, section added to datasheet.
Interface”, protocol specification compatibilities updated.
Interface”, “When REMAP = 1.....” removed from 2nd paragraph.
Interface”, MMC and SDMC compatibility updated.
Controller”, removed reference to Polygon Fill, removed from Features also. 5206
Section 10.4.2 “ETM
0”, feature added.
0”, feature added.
E”, ISI_MCK removed from PE11 line of the table.
ROM”, changes to list under “Bootloader on a non-volatile
Table 12-1, ”AT91SAM9263 Ordering
™
47, updated.
” on page 41
30, /3 divider removed.
edited.
AT91SAM9263
Information”.
6395
5713
5282
Change
Request
Ref.
6053
5846
5903
rfo
5791/5793
5560
5425
5643
5329
4910
4967
4505
5029
4945
4146
4664
4834
4668
49