ST7232AK2-Auto STMicroelectronics, ST7232AK2-Auto Datasheet - Page 83

• Manufacturer Part Number: ST7232AK2-Auto
• Description: 8-bit MCU for automotive, 16 Kbyte Flash, 10-bit ADC, 4 timers, SPI, SCI
• Manufacturer: STMicroelectronics

Specifications of ST7232AK2-Auto

• Hdflash Endurance: 100 cycles, data retention
• Clock Sources: crystal/ceramic resonator oscillators and bypass for external clock
• Four Power Saving Modes: halt, active halt, wait and slow
• Main Clock Controller With: real time base, beep and clock-out capabilities
• Two 16-bit Timers With: 2 input captures, 2 output compares, PWM and pulse generator modes

ST7232Axx-Auto
Input capture
In this section, the index, i, may be 1 or 2 because there are 2 input capture functions in the
16-bit timer.
The two 16-bit input capture registers (IC1R and IC2R) are used to latch the value of the
free running counter after a transition is detected on the ICAPi pin (see below).
ICiR register is a read-only register.
The active transition is software programmable through the IEDGi bit of Control Registers
(CRi).
Timing resolution is one count of the free running counter: (
Procedure
To use the input capture function select the following in the CR2 register:
●
●
Select the following in the CR1 register:
●
●
When an input capture occurs:
●
●
●
Clearing the input capture interrupt request (i.e. clearing the ICFi bit) is done in two steps:
1.
2.
The timer clock (CC[1:0]) (see
The edge of the active transition on the ICAP2 pin with the IEDG2 bit (the ICAP2 pin
must be configured as floating input or input with pull-up without interrupt if this
configuration is available).
Set the ICIE bit to generate an interrupt after an input capture coming from either the
ICAP1 pin or the ICAP2 pin.
Select the edge of the active transition on the ICAP1 pin with the IEDG1 bit (the
ICAP1pin must be configured as floating input or input with pull-up without interrupt if
this configuration is available).
ICFi bit is set
The ICiR register contains the value of the free running counter on the active transition
on the ICAPi pin (see
A timer interrupt is generated if the ICIE bit is set and the I bit is cleared in the CC
register. Otherwise, the interrupt remains pending until both conditions become true.
By reading the SR register while the ICFi bit is set
By accessing (reading or writing) the ICiLR register
ICiR
Figure
38).
Table 36: CR2 register
ICiHR
MSB
description)
f
CPU
/
CC[1:0]).
On-chip peripherals
ICiLR
LSB
83/201