ST7232AK2-Auto STMicroelectronics, ST7232AK2-Auto Datasheet - Page 96

• Manufacturer Part Number: ST7232AK2-Auto
• Description: 8-bit MCU for automotive, 16 Kbyte Flash, 10-bit ADC, 4 timers, SPI, SCI
• Manufacturer: STMicroelectronics

Specifications of ST7232AK2-Auto

• Hdflash Endurance: 100 cycles, data retention
• Clock Sources: crystal/ceramic resonator oscillators and bypass for external clock
• Four Power Saving Modes: halt, active halt, wait and slow
• Main Clock Controller With: real time base, beep and clock-out capabilities
• Two 16-bit Timers With: 2 input captures, 2 output compares, PWM and pulse generator modes

On-chip peripherals
96/201
Table 35.
Bit
4
3
2
1
0
CR1 register description (continued)
Bit name
FOLV2
FOLV1
OLVL2
IEDG1
OLVL1
Forced output compare 2
Forced output compare 1
Output level 2
Input edge 1
Output level 1
This bit is set and cleared by software.
0: No effect on the OCMP2 pin
1: Forces the OLVL2 bit to be copied to the OCMP2 pin, if the OC2E
bit is set and even if there is no successful comparison
This bit is set and cleared by software.
0: No effect on the OCMP1 pin
1: Forces OLVL1 to be copied to the OCMP1 pin, if the OC1E bit is
set and even if there is no successful comparison
This bit is copied to the OCMP2 pin whenever a successful
comparison occurs with the OC2R register and OCxE is set in the
CR2 register. This value is copied to the OCMP1 pin in one pulse
mode and pulse width modulation mode.
This bit determines which type of level transition on the ICAP1 pin
triggers the capture.
0: A falling edge triggers the capture
1: A rising edge triggers the capture
The OLVL1 bit is copied to the OCMP1 pin whenever a successful
comparison occurs with the OC1R register and the OC1E bit is set in
the CR2 register.
Function
ST7232Axx-Auto