LM3S8930 Luminary Micro, Inc, LM3S8930 Datasheet - Page 202

• Manufacturer Part Number: LM3S8930
• Description: Lm3s8930 Arm Microcontroller
• Manufacturer: Luminary Micro, Inc

General-Purpose Timers
10
10.1
202
General-Purpose Timers
Programmable timers can be used to count or time external events that drive the Timer input pins.
The Stellaris
Timer 2, and Timer 3). Each GPTM block provides two 16-bit timers/counters (referred to as TimerA
and TimerB) that can be configured to operate independently as timers or event counters, or
configured to operate as one 32-bit timer or one 32-bit Real-Time Clock (RTC).
The General-Purpose Timer Module is one timing resource available on the Stellaris
Other timer resources include the System Timer (SysTick) (see “System Timer
(SysTick)” on page 39).
The following modes are supported:
■
■
■
■
Block Diagram
Note:
32-bit Timer modes
–
–
–
–
16-bit Timer modes
–
–
–
–
16-bit Input Capture modes
–
–
16-bit PWM mode
–
Programmable one-shot timer
Programmable periodic timer
Real-Time Clock using 32.768-KHz input clock
Software-controlled event stalling (excluding RTC mode)
General-purpose timer function with an 8-bit prescaler (for one-shot and periodic modes only)
Programmable one-shot timer
Programmable periodic timer
Software-controlled event stalling
Input edge count capture
Input edge time capture
Simple PWM mode with software-programmable output inversion of the PWM signal
In Figure 10-1 on page 203, the specific CCP pins available depend on the Stellaris
See Table 10-1 on page 203 for the available CCPs.
®
General-Purpose Timer Module (GPTM) contains four GPTM blocks (Timer0, Timer1,
Preliminary
®
microcontrollers.
July 25, 2008
®
device.