hd64338342hw Renesas Electronics Corporation., hd64338342hw Datasheet - Page 129

• Manufacturer Part Number: hd64338342hw
• Description: Renesas 8-bit Single-chip Microcomputer H8 Family/h8/300l Super Low Power Series
• Manufacturer: Renesas Electronics Corporation.

3.1
Exception handling is performed in the H8/3847R Group when a reset or interrupt occurs. Table
3.1 shows the priorities of these two types of exception handling.
Table 3.1
Priority
High
Low
3.2
3.2.1
A reset is the highest-priority exception. The internal state of the CPU and the registers of the on-
chip peripheral modules are initialized.
3.2.2
As soon as the RES pin goes low, all processing is stopped and the chip enters the reset state.
To make sure the chip is reset properly, observe the following precautions.
Reset exception handling takes place as follows.
At power on: Hold the RES pin low until the clock pulse generator output stabilizes.
Resetting during operation: Hold the RES pin low for at least 10 system clock cycles.
The CPU internal state and the registers of on-chip peripheral modules are initialized, with the
I bit of the condition code register (CCR) set to 1.
The PC is loaded from the reset exception handling vector address (H'0000 to H'0001), after
which the program starts executing from the address indicated in PC.
Reset
Overview
Overview
Reset Sequence
Exception Source
Reset
Interrupt
Exception Handling Types and Priorities
Section 3 Exception Handling
Exception handling starts as soon as the reset state is cleared
Time of Start of Exception Handling
When an interrupt is requested, exception handling starts after
execution of the present instruction or the exception handling in
progress is completed
Rev. 6.00 Aug 04, 2006 page 93 of 680
Section 3 Exception Handling
REJ09B0145-0600