sc16c2550b NXP Semiconductors, sc16c2550b Datasheet - Page 23

• Manufacturer Part Number: sc16c2550b
• Description: 5 V, 3.3 V And 2.5 V Dual Uart, 5 Mbit/s Max. , With 16-byte Fifos
• Manufacturer: NXP Semiconductors

NXP Semiconductors
SC16C2550B_4
Product data sheet
7.8 Modem Status Register (MSR)
Table 19.
This register provides the current state of the control interface signals from the modem or
other peripheral device to which the SC16C2550B is connected. Four bits of this register
are used to indicate the changed information. These bits are set to a logic 1 whenever a
control input from the modem changes state. These bits are set to a logic 0 whenever the
CPU reads this register.
Table 20.
[1]
Bit
0
Bit
7
6
5
4
3
2
1
0
Whenever any MSR bit 3:0 is set to logic 1, a Modem Status Interrupt will be generated.
Symbol
LSR[0]
Symbol
MSR[7]
MSR[6]
MSR[5]
MSR[4]
MSR[3]
MSR[2]
MSR[1]
MSR[0]
Line Status Register bits description
Modem Status Register bits description
5 V, 3.3 V and 2.5 V dual UART, 5 Mbit/s (max.), with 16-byte FIFOs
Description
Receive data ready.
Description
CD. During normal operation, this bit is the complement of the CD input.
Reading this bit in the Loop-back mode produces the state of MCR[3] (OP2).
RI. During normal operation, this bit is the complement of the RI input.
Reading this bit in the Loop-back mode produces the state of MCR[2] (OP1).
DSR. During normal operation, this bit is the complement of the DSR input.
During the Loop-back mode, this bit is equivalent to MCR[0] (DTR).
CTS. During normal operation, this bit is the complement of the CTS input.
During the Loop-back mode, this bit is equivalent to MCR[1] (RTS).
CD
RI
DSR
CTS
Rev. 04 — 15 February 2007
logic 0 = no data in Receive Holding Register or FIFO (normal default
condition)
logic 1 = data has been received and is saved in the Receive Holding
Register or FIFO
logic 0 = no CD change (normal default condition)
logic 1 = the CD input to the SC16C2550B has changed state since the
last time it was read. A modem Status Interrupt will be generated.
logic 0 = no RI change (normal default condition)
logic 1 = the RI input to the SC16C2550B has changed from a logic 0 to a
logic 1. A modem Status Interrupt will be generated.
logic 0 = no DSR change (normal default condition)
logic 1 = the DSR input to the SC16C2550B has changed state since the
last time it was read. A modem Status Interrupt will be generated.
logic 0 = no CTS change (normal default condition)
logic 1 = the CTS input to the SC16C2550B has changed state since the
last time it was read. A modem Status Interrupt will be generated.
[1]
[1]
[1]
[1]
…continued
SC16C2550B
© NXP B.V. 2007. All rights reserved.
23 of 43