wm8215 Wolfson Microelectronics plc, wm8215 Datasheet - Page 21

• Manufacturer Part Number: wm8215
• Description: 60msps 10-bit 3-channel Ccd Digitiser
• Manufacturer: Wolfson Microelectronics plc

WM8215
w
SERIAL INTERFACE: REGISTER WRITE
Figure 16 shows register writing in serial mode. Three pins, SCK, SDI and SEN are used. A six-bit
address (a5, 0, a3, a2, a1, a0) is clocked in through SDI, MSB first, followed by an eight-bit data
word (b7, b6, b5, b4, b3, b2, b1, b0), also MSB first. Setting address bit a4 to 0 indicates that the
operation is a register write. Each bit is latched on the rising edge of SCK. When the data has been
shifted into the device, a pulse is applied to SEN to transfer the data to the appropriate internal
register.
Figure 16 Serial Interface Register Write
A software reset is carried out by writing to Address “000100” with any value of data, (i.e. Data Word
= XXXXXXXX).
SERIAL INTERFACE: REGISTER READ-BACK
Figure 17 shows register read-back in serial mode. Read-back is initiated by writing to the serial bus
as described above but with address bit a4 set to 1, followed by an 8-bit dummy data word. Writing
address (a5, 1, a3, a2, a1, a0) will cause the contents (d7, d6, d5, d4, d3, d2, d1, d0) of
corresponding register (a5, 0, a3, a2, a1, a0) to be output MSB first on pin SDO (on the falling edge
of SCK). Note that pin SDO is shared with an output pin, OP[9], therefore OEB should always be
held low and the OPD register bit should be set low when register read-back data is expected on this
pin. The next word may be read in to SDI while the previous word is still being output on SDO.
Figure 17 Serial Interface Register Read-back
SCK
SEN
SDI
a5
0
Address
a3
a2
a1
a0
b7
b6
b5
Data Word
b4
b3
b2
PD, Rev 4.2, February 2009
b1
b0
Production Data
21