MC2GH256NMCA-2SA00 SAMSUNG [Samsung semiconductor], MC2GH256NMCA-2SA00 Datasheet - Page 97

• Manufacturer Part Number: MC2GH256NMCA-2SA00
• Description: SAMSUNG MultiMediaCard
• Manufacturer: SAMSUNG [Samsung semiconductor]

Block Length Error R1 R2
WP violation
Com CRC Error
Illegal Command
Switch Error
Card ECC failed
Card Error
Execution Error
WP Erase Skip
Lock/Unlock Cmd
Failed
Card Is Locked
Erase Reset
In Idle State
CSD Overwrite
Revision 0.3
Idnetifier
R2
R1 R2
R1 R2
R1 R2
R2 DataErr
R2 DataErr
R2 DataErr
R2
R2
R2
R1 R2
R1 R2
R2
Included
in rep
E
E
E
E
E
E
E
E
E
S
E
S
E
S
Type
R
X
R
R
X
X
R
X
X
X
R
X
Mode
Det
’0’= no error
’1’= error
’0’= not pro-
tected
’1’= protected
’0’= no error
’1’= error
’0’= no error
’1’= error
’0’= no error
’1’= error
’0’= success
’1’= failure
’0’= no error
’1’= error
’0’= no error
’1’= error
tected
’1’= protected
’0’= no error
’1’= error
‘0’ = card is
not locked
‘1’ = card is
locked
’0’= cleared
’1’= set
0 = Card is
ready
1 = Card is in
idle state
’0’= no error
’1’= error
’0’= not pro-
Value
97
Either the argument of a SET_BLOCKLEN
command exceeds the maximum allowed
value for the card, or the previously defined
block length is illegal for the current com-
mand (e.g. the host is issues a write com-
mand and the current block length is
smaller than the card maximum value and
write partial blocks is not allowed)
Attempt to program a write protected block. C
The CRC check of the received command
failed.
The received command is not legal for the
card state.
If set, the card did not switch to the
expected mode as requested by the
SWITCH command
Card internal ECC was applied but failed to
correct the data.
(Undefined by the standard)
A card error occurred, which is not related
to the host command.
(Undefined by the standard)
A generic card error related to the (and
detected during) execution of the last host
command (e.g. read or write failures).
Only partial address space was erased due
to existing write protected blocks.
Sequence or password error during card
lock/unlock operation.
Card is locked by a user password
An erase sequence was cleared before
executing because an out of erase
sequence command was received.(other
than CMD35, CMD36, CMD38 or CMD13)
The card enters the idle state after power
up or reset command. It will exit this state
and become ready upon completion of its
initialization procedures.
The host is trying to change the ROM sec-
tion, or is trying to reverse the copy bit (set
as original) or permanent WP bit (un-pro-
tect) of the CSD register.
Description
MultiMediaCard
Sep.22.2005
C
C
C
C
C
C
C
C
C
A
C
A
C
Clear
Cond
TM