PIC18F2525 MICROCHIP [Microchip Technology], PIC18F2525 Datasheet - Page 206

• Manufacturer Part Number: PIC18F2525
• Description: 28/40/44-Pin Enhanced Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology
• Manufacturer: MICROCHIP [Microchip Technology]

PIC18F2525/2620/4525/4620
REGISTER 18-3:
DS39626B-page 204
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
BAUDCON: BAUD RATE CONTROL REGISTER
bit 7
ABDOVF: Auto-Baud Acquisition Rollover Status bit
1 = A BRG rollover has occurred during Auto-Baud Rate Detect mode
0 = No BRG rollover has occurred
RCIDL: Receive Operation Idle Status bit
1 = Receive operation is Idle
0 = Receive operation is active
Unimplemented: Read as ‘0’
SCKP: Synchronous Clock Polarity Select bit
Asynchronous mode:
Unused in this mode.
Synchronous mode:
1 = Idle state for clock (CK) is a high level
0 = Idle state for clock (CK) is a low level
BRG16: 16-bit Baud Rate Register Enable bit
1 = 16-bit Baud Rate Generator – SPBRGH and SPBRG
0 = 8-bit Baud Rate Generator – SPBRG only (Compatible mode), SPBRGH value ignored
Unimplemented: Read as ‘0’
WUE: Wake-up Enable bit
Asynchronous mode:
1 = EUSART will continue to sample the RX pin – interrupt generated on falling edge; bit
0 = RX pin not monitored or rising edge detected
Synchronous mode:
Unused in this mode.
ABDEN: Auto-Baud Detect Enable bit
Asynchronous mode:
1 = Enable baud rate measurement on the next character. Requires reception of a Sync field
0 = Baud rate measurement disabled or completed
Synchronous mode:
Unused in this mode.
Legend:
R = Readable bit
-n = Value at POR
ABDOVF
R/W-0
(must be cleared in software)
cleared in hardware on following rising edge
(55h); cleared in hardware upon completion
RCIDL
R-1
U-0
Preliminary
—
W = Writable bit
‘1’ = Bit is set
R/W-0
SCKP
BRG16
R/W-0
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
U-0
—
 2004 Microchip Technology Inc.
x = Bit is unknown
R/W-0
WUE
ABDEN
R/W-0
bit 0