M58LT128HSB8ZA6 NUMONYX [Numonyx B.V], M58LT128HSB8ZA6 Datasheet - Page 108

• Manufacturer Part Number: M58LT128HSB8ZA6
• Manufacturer: NUMONYX [Numonyx B.V]

Command Interface state tables
Table 44.
1. The output state shows the type of data that appears at the outputs if the bank address is the same as the command
2. CI = Command Interface, CR = Configuration Register, BEFP = Buffer Enhanced Factory Program, P/E. C. =
3. If the Program/Erase Controller is active, both cycles are ignored.
4. BEFP Exit when block address is different from first block address and data are FFFFh.
5. Illegal commands are those not defined in the command set.
108/110
Buffer Program Suspend in
Program Suspend in Erase
Buffer Program Suspend
Program/Erase Suspend
Buffer Program Busy in
Program Busy in Erase
address. A bank can be placed in Read Array, Read Status Register, Read Electronic Signature or Read CFI mode,
depending on the command issued. Each bank remains in its last output state until a new command is issued to that bank.
The next state does not depend on the bank's output state.
Program/Erase Controller.
Buffer Program Busy
Blank Check busy
Current CI State
Erase Suspend
Erase Suspend
Program Busy
Illegal State
Erase Busy
OTP Busy
Suspend
Suspend
Ready
Command interface states - lock table, next output state (continued)
Protect/CR
Setup
(60h)
(3)
Status Register
setup (BCh)
Check
Blank
Setup
(C0h)
OTP
(3)
Blank Check
confirm
(CBh)
Output Unchanged
Output Unchanged
Command Input
Block Protect
Confirm (01h)
Confirm
Set CR
M58LT128HST, M58LT128HSB
(03h)
(FFFFh)
Exit
BEFP
Array
(4)
Command
(1) (2)
Illegal
Output Unchanged
(5)
Completed
Operation
P. E./C.