M38039G4H-XXXHP RENESAS [Renesas Technology Corp], M38039G4H-XXXHP Datasheet - Page 52

• Manufacturer Part Number: M38039G4H-XXXHP
• Description: SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
• Manufacturer: RENESAS [Renesas Technology Corp]

3803 Group (Spec.H QzROM version)
Rev.1.10
REJ03B0166-0110
[Transmit Buffer Register 3/Receive Buffer Register 3
(TB3/RB3)] 0030
The transmit buffer register 3 and the receive buffer register 3 are
located at the same address. The transmit buffer is write-only and
the receive buffer is read-only. If a character bit length is 7 bits,
the MSB of data stored in the receive buffer is “0”.
[Serial I/O3 Status Register (SIO3STS)] 0031
The read-only serial I/O3 status register consists of seven flags
(bits 0 to 6) which indicate the operating status of the serial I/O3
function and various errors.
Three of the flags (bits 4 to 6) are valid only in UART mode.
The receive buffer full flag (bit 1) is cleared to “0” when the
receive buffer register is read.
If there is an error, it is detected at the same time that data is
transferred from the receive shift register to the receive buffer
register, and the receive buffer full flag is set. A write to the
serial I/O3 status register clears all the error flags OE, PE, FE,
and SE (bit 3 to bit 6, respectively). Writing “0” to the serial I/O3
enable bit SIOE (bit 7 of the serial I/O3 control register) also
clears all the status flags, including the error flags.
Bits 0 to 6 of the serial I/O3 status register are initialized to “0” at
reset, but if the transmit enable bit (bit 4) of the serial I/O3
control register has been set to “1”, the transmit shift completion
flag (bit 2) and the transmit buffer empty flag (bit 0) become “1”.
[Serial I/O3 Control Register (SIO3CON)] 0032
The serial I/O3 control register consists of eight control bits for
the serial I/O3 function.
[UART3 Control Register (UART3CON)] 0033
The UART control register consists of four control bits (bits 0 to
3) which are valid when asynchronous serial I/O is selected and
set the data format of an data transfer, and one bit (bit 4) which is
always valid and sets the output structure of the P3
[Baud Rate Generator 3 (BRG3)] 002F
The baud rate generator determines the baud rate for serial
transfer.
The baud rate generator divides the frequency of the count source
by 1/(n + 1), where n is the value written to the baud rate
generator.
Nov 14, 2005
16
Page 52 of 91
16
5
16
/T
16
16
X
D
3
pin.
PRELIMINARY
Notice: This is not a final specification.
Some parametric limits are subject to change.