CYIL1SM0300AA CYPRESS [Cypress Semiconductor], CYIL1SM0300AA Datasheet - Page 34

• Manufacturer Part Number: CYIL1SM0300AA
• Description: LUPA-300 CMOS Image Sensor
• Manufacturer: CYPRESS [Cypress Semiconductor]

Document Number: 001-00371 Rev. *D
Handling Precautions
Special care should be given when soldering image sensors
with color filter arrays (RGB color filters), onto a circuit board,
since color filters are sensitive to high temperatures.
Prolonged heating at elevated temperatures may result in
deterioration of the performance of the sensor. The following
recommendations are made to ensure that sensor perfor-
mance is not compromised during end-users' assembly
processes.
Board Assembly:
Device placement onto boards should be done in accordance
with strict ESD controls for Class 0, JESD22 Human Body
Model, and Class A, JESD22 Machine Model devices.
Assembly operators should always wear all designated and
approved grounding equipment; grounded wrist straps at ESD
protected workstations are recommended including the use of
ionized blowers. All tools should be ESD protected.
Manual Soldering:
When a soldering iron is used the following conditions should
be observed:
Precautions and cleaning:
Avoid spilling solder flux on the cover glass; bare glass and
particularly glass with antireflection filters may be adversely
affected by the flux. Avoid mechanical or particulate damage
to the cover glass.
It is recommended that isopropyl alcohol (IPA) be used as a
solvent for cleaning the image sensor glass lid. When using
other solvents, it should be confirmed beforehand whether the
solvent will dissolve the package and/or the glass lid or not.
• Use a soldering iron with temperature control at the tip.
• The soldering iron tip temperature should not exceed
• The soldering period for each pin should be less than 5
350°C.
seconds.
CYIL1SM0300AA
Page 34 of 36
[+] Feedback
[+] Feedback