NAND08GW3F2AN6E NUMONYX, NAND08GW3F2AN6E Datasheet - Page 19

• Manufacturer Part Number: NAND08GW3F2AN6E
• Description: IC FLASH 8GBIT SLC 48TSOP
• Manufacturer: NUMONYX

Specifications of NAND08GW3F2AN6E

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 8G (1G x 8)
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -

NAND08GW3F2A, NAND16GW3F2A
6
6.1
6.1.1
Device operations
Single plane operations
This section gives the details of the single plane device operations.
Page read
At power-up the device defaults to read mode. To enter read mode from another mode the
Read command must be issued, see
issued, subsequent consecutive read commands only require the confirm command code
(30h).
After a first page read operation, the device stays in read mode and a second page read can
be started by inputting 5 address cycles and a read confirm command.
Once a read command is issued, two types of operations are available: random read and
sequential page read. The random read mode is enabled when the page address is
changed.
After the first random read access, the page data (4224 bytes) is transferred to the page
buffer in a time of t
the transfer is complete, the Ready/Busy signal goes High. The data can then be read out
sequentially (from the selected column address to last column address) by pulsing the Read
Enable signal (see
The device can output random data in a page, instead of the consecutive sequential data, by
issuing a Random Data Output command. The Random Data Output command can be used
to skip some data during a sequential data output.
The sequential operation can be resumed by changing the column address of the next data
to be output, to the address which follows the Random Data Output command. The Random
Data Output command can be issued as many times as required within a page.
WHBH
Figure 39: Page read operation AC
(refer to
Table 21: AC characteristics for operations
Table 7: Command
waveforms).
set. Once a Read command is
Device operations
for value). Once
19/65