PCA9626B,118 NXP Semiconductors, PCA9626B,118 Datasheet - Page 27

• Manufacturer Part Number: PCA9626B,118
• Description: IC LED DRIVER RGBA 48-LQFP
• Manufacturer: NXP Semiconductors
• Type: RGBA LED Driverr

Specifications of PCA9626B,118

• Package / Case: 48-LQFP
• Topology: Open Drain, PWM
• Number Of Outputs: 24
• Internal Driver: Yes
• Type - Primary: Backlight, LED Blinker
• Type - Secondary: RGBA
• Frequency: 1MHz
• Voltage - Supply: 2.3 V ~ 5.5 V
• Voltage - Output: 40V
• Mounting Type: Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Current - Output / Channel: 100mA
• Internal Switch(s): Yes
• Number Of Segments: 24
• Low Level Output Current: 100000 uA (Min)
• Operating Supply Voltage: 2.3 V to 5.5 V
• Maximum Supply Current: 18000 uA
• Maximum Power Dissipation: 1800 mW
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Efficiency: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 568-4774-2

NXP Semiconductors
PCA9626_2
Product data sheet
Fig 10. System configuration
SDA
SCL
TRANSMITTER/
RECEIVER
MASTER
8.3 Acknowledge
The number of data bytes transferred between the START and the STOP conditions from
transmitter to receiver is not limited. Each byte of eight bits is followed by one
acknowledge bit. The acknowledge bit is a HIGH level put on the bus by the transmitter,
whereas the master generates an extra acknowledge related clock pulse.
A slave receiver which is addressed must generate an acknowledge after the reception of
each byte. Also a master must generate an acknowledge after the reception of each byte
that has been clocked out of the slave transmitter. The device that acknowledges has to
pull down the SDA line during the acknowledge clock pulse, so that the SDA line is stable
LOW during the HIGH period of the acknowledge related clock pulse; set-up time and hold
time must be taken into account.
A master receiver must signal an end of data to the transmitter by not generating an
acknowledge on the last byte that has been clocked out of the slave. In this event, the
transmitter must leave the data line HIGH to enable the master to generate a STOP
condition.
Fig 11. Acknowledgement on the I
RECEIVER
SLAVE
SCL from master
by transmitter
data output
by receiver
data output
TRANSMITTER/
Rev. 02 — 31 August 2009
RECEIVER
condition
START
SLAVE
S
2
C-bus
TRANSMITTER
1
MASTER
24-bit Fm+ I
2
TRANSMITTER/
RECEIVER
MASTER
acknowledgement
2
not acknowledge
C-bus 100 mA 40 V LED driver
SLAVE
clock pulse for
acknowledge
8
MULTIPLEXER
PCA9626
© NXP B.V. 2009. All rights reserved.
002aaa987
I
2
9
C-BUS
002aaa966
27 of 47