STEVAL-ISF002V1 STMicroelectronics, STEVAL-ISF002V1 Datasheet - Page 40

• Manufacturer Part Number: STEVAL-ISF002V1
• Description: BOARD EVALUATION
• Manufacturer: STMicroelectronics

Specifications of STEVAL-ISF002V1

• Main Purpose: *
• Embedded: *
• Utilized Ic / Part: *
• Primary Attributes: *
• Secondary Attributes: *
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-10422

Starting the PFC application
7
7.1
7.2
7.3
40/62
Starting the PFC application
This chapter explains how to configure the demonstrator.
Hardware requirements
●
●
●
●
●
●
●
●
●
●
Software requirements
●
●
The software demonstration source code is provided by STMicroelectronics free of charge
(after acceptance of the license agreement during the installation procedure).
The firmware can be customized with your own preferred development tool and downloaded
into the internal Flash memory of the STM32 through a JTAG interface present on the
STEVAL-IHM022V1.
Jumper settings
Table 3
STEVAL-IHM022V1 demonstration board respectively. Note that
jumpers used from the digital PFC; all other jumper settings must be left as default.
Table 3.
STEVAL-ISF002V1 PFC power board
34-pin flat cable
AC power source able to supply the appropriate voltage and current
DC electronic load able to provide the appropriate load
STEVAL-IHM022V1 dual motor control demonstration board
5 V / 2 A DC power supply to supply the STEVAL-IHM022V1
J-Link-ARM-KS
USB cable (A and B type plug)
20-pin flat cable
PC
IAR embedded workbench for ARM 5.20
IAR project for digital PFC based on the STM32F103ZE microcontroller
Name
JP9
and
Table 4
PFC power board STEVAL-ISF002V1 jumper settings
Selection
show the jumper settings for the STEVAL-ISF002V1 power board and
1 2
1 2
Doc ID 16854 Rev 1
VIPER12 is enabled. J10 connector must be open.
VIPER12 is disabled. 15 V must be provided by J10 connector.
Description
Table 4
only describes the
UM0877