STEVAL-ISQ002V1 STMicroelectronics, STEVAL-ISQ002V1 Datasheet - Page 29

• Manufacturer Part Number: STEVAL-ISQ002V1
• Description: BOARD EVAL BASED ON ST72264G1
• Manufacturer: STMicroelectronics

Specifications of STEVAL-ISQ002V1

• Main Purpose: Interface, PMBus
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST72F264
• Primary Attributes: The PMBus™ Interface Using the ST7 I2C Peripheral
• Secondary Attributes: Firmware in C Language
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6423

AN2511
2.
d)
Power settings: The demonstration board can be powered by one of the following
options:
a)
b)
runs using the resonator clock (16 MHz). If the jumper is connected between pins
2 and 3 then the application is stopped and ST7 MCU can be re-programmed.
JP4: JP4 is used to select the power supply as described below. From the JP4
side, if the jumper is connected between pins 2 and 3 then the application runs
using the direct supply given from `POWER' connector. If the jumper is connected
between pins 1 and 2 then the application runs using the DC adapter supply given
from J1.
DC adapter: Connect a DC adapter to J1. The DC adapter should supply a
minimum of 7 V and maximum of 18 V, 1 A. This supply is regulated to 5 V supply
using an L7805 regulator.
Regulated supply: The user can use a direct 3 V to 5 V supply. The supply and
Gnd points should be connected to the `POWER' connector pins 1 and 2. Here,
`POWER' connector pin 1 is referred from the JP4 jumper side (from the right
side).
Doc ID 13286 Rev 2
PMBus demonstration board
29/43