STEVAL-IHM010V1 STMicroelectronics, STEVAL-IHM010V1 Datasheet - Page 33

• Manufacturer Part Number: STEVAL-IHM010V1
• Description: KIT IGBT PWR MODULE CTRL ST7MC
• Manufacturer: STMicroelectronics
• Type: Motor / Motion Controllers & Driversr

Specifications of STEVAL-IHM010V1

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST7FMC2S4
• Primary Attributes: 3-Ph Brushless BLDC, AC & 3-Ph AC Induction (ACIM) Motors
• Secondary Attributes: Graphic User Interface, 4 Pots for Runtime Settings, Start/Stop and Reset Buttons
• Input Voltage: 5 V
• Product: Power Management Modules
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: ARM7TDMI
• Silicon Core Number: ST7
• Silicon Family Name: ST7MCx
• Kit Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ST7MC
• Other names: 497-8400

UM0430
7.4.12
3
Programming the firmware
Before programming the firmware, the control board must be supplied and connected to the
PC using the inDART board. We suggest setting up the system as in
Figure 18. System setup for programming phase
1.
Windows 2000® and Windows XP® may issue a warning the first time the inDART-STX
Power Board is connected to the PC. The USB driver used by inDART-STX is not digitally
signed by Microsoft, however, the user may safely ignore the warning since every kind of
compatibility and security test has been carried out by Softec Microsystems.
2.
3.
Use the USB cable to connect the inDART-STX Board to the PC. The green "power"
LED on the inDART-STX Board turns on. The Windows® operating system
automatically detects the new hardware and loads the appropriate USB and inDART-
STX drivers.
Connect the inDART Board with the control board J1 connector using the 10-pin flat
cable.
Supply the control board using 5 V power supply connected to J6 observing the
polarity.
Motor control demonstration
Figure
18.
33/48