STEVAL-IHM010V1 STMicroelectronics, STEVAL-IHM010V1 Datasheet - Page 35

• Manufacturer Part Number: STEVAL-IHM010V1
• Description: KIT IGBT PWR MODULE CTRL ST7MC
• Manufacturer: STMicroelectronics
• Type: Motor / Motion Controllers & Driversr

Specifications of STEVAL-IHM010V1

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST7FMC2S4
• Primary Attributes: 3-Ph Brushless BLDC, AC & 3-Ph AC Induction (ACIM) Motors
• Secondary Attributes: Graphic User Interface, 4 Pots for Runtime Settings, Start/Stop and Reset Buttons
• Input Voltage: 5 V
• Product: Power Management Modules
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: ARM7TDMI
• Silicon Core Number: ST7
• Silicon Family Name: ST7MCx
• Kit Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ST7MC
• Other names: 497-8400

UM0430
7.4.14
7.4.15
Figure 20. Programming option auto window
12. Press start to program the device.
If an error window appears, make sure that the inDART-STX board is connected to the
ControlBDST7MC2 control board and that the control board is well supplied.
Jumper setting table
Table 12.
Board connection
After the board has been programmed, the system can be configured as shown in
Figure
preventively configured (see the power board user manual). Remove the ICC flat cable from
the control board if present.
Name
J2
J5
J7
J8
21. This configuration is called a “running configuration”. The power board must be
Jumper settings
Between 1-2
Between 2-3
Selection
Closed
Open
Open
Enable the auxiliary flash memory M95040. Debug feature can not be
microcontroller PWM-W - Only for “3 Phase BLAC/DC (trapezoidal)”
No current reference is required – For “3 Phase AC Induction Motor
Disable the auxiliary flash memory M95040. Debug feature can be
Variable – The current reference value (MCCREF) is driven by the
potentiometer P4 – Only for “3 Phase BLAC/DC (trapezoidal)”
Adjustable – The current reference value (MCCREF) is set by
(sinewave)” and “3 Phase PMAC Motor (sinewave)”
This point is connected to C & D debug pin
This point is connected to C & Z debug pin
Description
enabled.
enabled.
Motor control demonstration
35/48