PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 73

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PG-FP5
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
(8) [Autoprocedure(E.P.)] command
<When using 78K0, 78K0S (other than 78K0S/Kx1+ microcontrollers and
The progress status of this command is displayed in the action log window. When execution of this command is
completed, the programming GUI displays the result of command execution in the target device. Command
options after execution of this command depend on the settings of the [Blank check before Erase], [Verify after
Program], [Security after Program], and [Checksum after Program] check boxes in the [Command options] area on
the [Advanced] tab in the Device Setup dialog box. For details on these check boxes, refer to 4.3.3 (14) (c) <2>
[Command options] area.
Remark
<When using a 78K0S/Kx1+ microcontroller or
Remark
Method: Division (original)
Range: Area set in the [Operation Mode] area on the [Standard] tab in the Device Setup dialog box
The [Autoprocedure(E.P.)] command executes the [Erase] and [Program] commands in succession. Exiting
from the flash memory programming mode is not possible between the [Erase] and [Program] commands.
The target area can be set in the [Operation Mode] area on the [Standard] tab in the Device Setup dialog box.
With the 16-bit arithmetic (subtraction) mode, the lower 4 digits of the result from which a value is
subtracted from 00h in 1-byte units are displayed.
For details on the arithmetic specifications, refer to Figure B-4 Division (Original) Calculation
Specifications.
Figure 4-42. Action Log Window After [Checksum] Command Execution
Figure 4-43. Action Log Window After [Checksum] Command Execution
<When using 78K0S/Kx1+ microcontroller or
>sum
0x623E
PASS
>
>sum
Device Checksum: 0x1842
FP5 Checksum:
Checksum compare: PASS
Checksum operation finished.
>
μ
PD78F9334>
0x1842
CHAPTER 4 PROGRAMMING GUI USAGE
μ
PD78F9334>
μ
PD78F9334), 78K0R, or V850>
Page 73 of 240