PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 91

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PG-FP5
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
<3> [Operation Mode] area
[On Target] check box
Specify which clock is supplied to the target device: a clock mounted on the target system, or a clock on the FP5
side. If this check box is selected, the clock mounted on the target system will be used. If this check box is
cleared, the clock on the FP5 side will be used.
[Multiply rate] text box
Set the multiplication ratio of the clock supplied to the target device. If the target device includes the PLL circuit,
input the multiplication ratio in accordance with the environment used. If the target device does not include the
PLL circuit, select “Internal/Direct mode”. On the initial screen, the default settings that have been loaded from
the PR5 file is displayed.
Switch the operation mode to execute commands, such as flash memory programming, for the entire flash
memory area, in area units or in block units. The settings made here are valid for the [Blank Check], [Erase],
[Program], [Verify], [Read], [Checksum], and [Autoprocedure(E.P.)] commands. The display varies depending on
whether or not the downloaded PR5 file is for a target device that supports data flash.
If [Chip] is selected:
The entire flash memory area of the target device is subject to command processing, such as programming.
Remark
Caution When loading an HCUHEX file, the HCUHEX file is handled as master data, so the [Chip] are
For the selectable multiply rate, refer to the user's manual for the device used.
selected. The setting of this check box therefore cannot be changed.
(a) The downloaded PR5 file is for a target device that does not support data flash
(b) The downloaded PR5 file is for a target device that supports data flash.
Figure 4-63. [Operation Mode] Area
CHAPTER 4 PROGRAMMING GUI USAGE
Page 91 of 240