101-0954 Rabbit Semiconductor, 101-0954 Datasheet - Page 13

• Manufacturer Part Number: 101-0954
• Description: KIT DEV RABBIT RCM3360/3370 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r

Specifications of 101-0954

• For Use With/related Products: RCM3360
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

2.1 Install Dynamic C
To develop and debug programs for the RCM3360/RCM3370 (and for all other Z-World
and Rabbit Semiconductor hardware), you must install and use Dynamic C.
If you have not yet installed Dynamic C version 9.01 (or a later version), do so now by
inserting the Dynamic C CD from the Development Kit in your PC’s CD-ROM drive. If
autorun is enabled, the CD installation will begin automatically.
If autorun is disabled or the installation otherwise does not start, use the Windows
Start | Run
of the CD-ROM.
The installation program will guide you through the installation process. Most steps of the
process are self-explanatory.
Dynamic C uses a COM (serial) port to communicate with the target development system.
The installation allows you to choose the COM port that will be used. The default selec-
tion is COM1. You may select any available port for Dynamic C’s use. If you are not cer-
tain which port is available, select COM1. This selection can be changed later within
Dynamic C.
Once your installation is complete, you will have up to three icons on your PC desktop.
One icon is for Dynamic C, one opens the documentation menu, and the third is for the
Rabbit Field Utility, a tool used to download precompiled software to a target system.
Install any Dynamic C modules after you have installed Dynamic C. The modules may be
installed in any order. You must install the modules in the same directory where
Dynamic C was installed.
User’s Manual
This chapter explains how to set up and use the RCM3360/
RCM3370 modules with the accompanying Prototyping Board.
NOTE: It is assumed that you have a Development Kit. If you purchased an RCM3360 or
NOTE: The installation utility does not check the selected COM port in any way. Speci-
RCM3370 module by itself, you will have to adapt the information in this chapter and
elsewhere to your test and development setup.
fying a port in use by another device (mouse, modem, etc.) may lead to a message such
as
menu or Windows Disk Explorer to launch
"could not open serial port"
2. G
when Dynamic C is started.
ETTING
setup.exe
from the root folder
S
TARTED
7