101-0954 Rabbit Semiconductor, 101-0954 Datasheet - Page 17

• Manufacturer Part Number: 101-0954
• Description: KIT DEV RABBIT RCM3360/3370 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r

Specifications of 101-0954

• For Use With/related Products: RCM3360
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

2.3 Starting Dynamic C
Once the RCM3360/RCM3370 is connected as described in the preceding pages, start
Dynamic C by double-clicking on the Dynamic C icon or by double-clicking on
dcrabXXXX.exe in the Dynamic C root directory, where XXXX are version-specific
characters.
Dynamic C uses the serial port on your PC that you specified during installation.
If you are using a USB port to connect your computer to the RCM3360/RCM3370 module,
choose
Communications
2.4 Run a Sample Program
Since the RCM3360 and the RCM3370 run at 44.2 MHz and are equipped with a fast
program-execution SRAM, you should first set the compiler to run the application in the
fast program execution SRAM by selecting
the Dynamic C
Use the
SAMPLES
window will open on your PC and will display a small square bouncing around in a box.
This program shows that the CPU is working. The sample program described in
Section 6.5, “Run the PINGME.C Sample Program,” tests the TCP/IP portion of the board.
2.4.1 Troubleshooting
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the
If Dynamic C cannot find the target system (error message "No Rabbit Processor
Detected."):
• Check that the RCM3360/RCM3370 is powered correctly —
• Check to make sure you are using the
• Check both ends of the programming cable to ensure that they are firmly plugged into
• Ensure that the RCM3360/RCM3370 module is firmly and correctly installed in its
User’s Manual
Communications
Prototyping Board should be lit when the RCM3360/RCM3370 is mounted on the Prototyping
Board and the AC adapter is plugged in
programming cable.
the PC and the programming port on the RCM3360/RCM3370.
connectors on the Prototyping Board.
Options > Project Options
File
folder. Press function key
menu to open the sample program
Serial Options
Options > Project Options > Compiler
tab.
menu. Choose a lower debug baud rate.
dialog in the Dynamic C
F9
and select “Use USB to Serial Converter” on the
.
to compile and run the program. The
PROG
Code and BIOS in Flash, Run in RAM
PONG.C
connector, not the
Options > Project Options >
, which is in the Dynamic C
menu.
the red core LED on the
DIAG
connector, on the
STDIO
from
11