101-0954 Rabbit Semiconductor, 101-0954 Datasheet - Page 22

• Manufacturer Part Number: 101-0954
• Description: KIT DEV RABBIT RCM3360/3370 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r

Specifications of 101-0954

• For Use With/related Products: RCM3360
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

•
16
As long as you have not modified the
enter the following server address in your Web browser to bring up the Web page
served by the sample program.
Otherwise use the TCP/IP settings you entered in the
This sample program does not exhibit ideal behavior in its method of writing to the
NAND flash. However, the inefficiency attributable to the small amount of data writ-
ten in each append operation is offset somewhat by the expected relative infrequency
of these writes, and by the sample program's method of “walking” through the flash
blocks when appending data as well as when a log is cleared.
NFLASH_ERASE.c
flash chip. When the program starts running, it attempts to establish communication
with the NAND flash chip selected by the user. If the communication is successful, the
progress in erasing the blocks is displayed in the Dynamic C
blocks are erased.
Follow these instructions to set up your PC or notebook. Check with your administra-
tor if you are unable to change the settings as described here since you may need
administrator privileges. The instructions are specifically for Windows 2000, but the
interface is similar for other versions of Windows.
1. Go to the control panel (
2. Select the network interface card used for the Ethernet interface you intend to use
3. Now select the
4. Click <OK> or <Close> to exit the various dialog boxes.
http://10.10.6.100
the Network icon.
(e.g.,
ties” button. Depending on which version of Windows your PC is running, you may
have to select the “Local Area Connection” first, and then click on the “Properties”
button to bring up the Ethernet interface dialog. Then “Configure” your interface
card for a “10Base-T Half-Duplex” or an “Auto-Negotiation” connection on the
“Advanced” tab.
and click on “Properties” to assign an IP address to your computer (this will disable
“obtain an IP address automatically”):
TIP: If you are using a PC that is already on a network, you will disconnect the PC
NOTE: Your network interface card will likely have a different name.
IP Address : 10.10.6.101
Netmask : 255.255.255.0
Default gateway : 10.10.6.1
TCP/IP Xircom Credit Card Network Adapter
from that network to run these sample programs. Write down the existing settings
before changing them to facilitate restoring them when you are finished with the
sample programs and reconnect your PC to the network.
IP Address
—This program is a utility to erase all the good blocks on a NAND
Start > Settings > Control Panel
tab, and check
TCPCONFIG 1
Specify an IP Address
TCP_CONFIG.LIB
macro in the sample program,
) and click on the “Proper-
RabbitCore RCM3360/RCM3370
STDIO
), and then double-click
, or select TCP/IP
window as the
library.