101-0954 Rabbit Semiconductor, 101-0954 Datasheet - Page 14

• Manufacturer Part Number: 101-0954
• Description: KIT DEV RABBIT RCM3360/3370 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r

Specifications of 101-0954

• For Use With/related Products: RCM3360
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

2.2 Hardware Connections
There are three steps to connecting the Prototyping Board for use with Dynamic C and the
sample programs:
1. Attach the RCM3360/RCM3370 module to the Prototyping Board.
2. Connect the programming cable between the RCM3360/RCM3370 and the workstation
3. Connect the power supply to the Prototyping Board.
2.2.1 Attach Module to Prototyping Board
Turn the RCM3360/RCM3370 module so that the Ethernet jack is facing the direction
shown in Figure 2 below. Align the pins from headers J3 and J4 on the bottom side of the
module into header sockets JA and JB on the Prototyping Board. The picture card (NAND
flash) does not have to be inserted into header J6 on the RCM3360/RCM3370 at this time.
Press the module’s pins firmly into the Prototyping Board header sockets.
8
PC.
NOTE: It is important that you line up the pins on headers J3 and J4 of the RCM3360/
Figure 2. Install the RCM3360/RCM3370 Module on the Prototyping Board
RCM3370 module exactly with the corresponding pins of header sockets JA and JB on
the Prototyping Board. The header pins may become bent or damaged if the pin align-
ment is offset, and the module will not work. Permanent electrical damage to the mod-
ule may also result if a misaligned module is powered up.
RabbitCore RCM3360/RCM3370