EVB9S12NE64 Freescale Semiconductor, EVB9S12NE64 Datasheet - Page 3

• Manufacturer Part Number: EVB9S12NE64
• Description: KIT EVALUATION FOR NE64
• Manufacturer: Freescale Semiconductor

Specifications of EVB9S12NE64

• Mfg Application Notes: MC9S12NE64 Integrated Ethernet Controller Implementing an Ethernet Interface with the MC9S12NE64 Web Server Development with MC9S12NE64 and Open TCP
• Processor To Be Evaluated: MC9S12NE64
• Data Bus Width: 16 bit
• Interface Type: RS-232, Ethernet
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

E V B 9 S 1 2 N E 6 4
TABLE 1: LCD COMMAND AND CHARACTER CODES..............................................................................................20
Cautionary Notes
1) Electrostatic Discharge (ESD) prevention measures should be applied whenever handling
2) Axiom Manufacturing reserves the right to make changes without further notice to any
products to improve reliability, function or design. Axiom Manufacturing does not assume any
liability arising out of the application or use of any product or circuit described herein; neither
does it convey any license under patent rights or the rights of others.
3) EMC Information on the EVB9S12NE64 board:
Terminology
This development board applies option selection jumpers. Terminology for application of the
option jumpers is as follows:
This development board applies hardwired option selections (VRL_EN and CUTAWAY 1 – 3).
These option selections apply a circuit trace between the option pads to complete a default
connection. This type connection places an equivalent Jumper Installed type option. The circuit
trace between the option pads maybe cut with a razor blade or similar type knife to isolate the
default connection provided. Applying the default connection again can be performed by
installing the option post pins and shunt jumper, or by applying a wire between the option
pads.
a) This product as shipped from the factory with associated power supplies and cables, has
b) This product is designed and intended for use as a development platform for hardware
c) In a domestic environment this product may cause radio interference in which case the
d) Attaching additional wiring to this product or modifying the products operation from the
this product. ESD damage is not a warranty repair item.
been tested and meets with requirements of CE and the FCC as a CLASS A product.
or software in an educational or professional laboratory.
user may be required to take adequate prevention measures.
factory default as shipped may effect its performance and also cause interference with
other apparatus in the immediate vicinity.
mitigating measures should be taken.
Jumper on, in, or installed = jumper is a plastic shunt that fits across 2 pins and the
shunt is installed so that the 2 pins are connected with the shunt.
Jumper off, out, or idle = jumper or shunt is installed so that only 1 pin holds the shunt,
no 2 pins are connected, or jumper is removed. It is recommended that the jumpers be
idled by installing on 1 pin so they will not be lost.
3
If such interference is detected, suitable
0 5 / 2 4 / 0 4