101-1272 Rabbit Semiconductor, 101-1272 Datasheet - Page 111

• Manufacturer Part Number: 101-1272
• Description: KIT MESH NETWORK ADD-ON RCM4510W
• Manufacturer: Rabbit Semiconductor
• Type: Microprocessorr

Specifications of 101-1272

• Product: Modules
• Data Bus Width: 12 bit
• Processor Type: Rabbit 4000
• Sram: 512 KB
• Number Of I/os: 20
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: RCM4510W
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1158

3. On the “PC Settings” tab, select the “USB Serial Port” corresponding to the USB serial
4. Under the “Modem Configuration” tab click the “Read” button. X-CTU will now display
5. Now set the networking parameters in your project defines or in the sample program to
6. Now set the networking parameters in your project defines or in the sample program to
7. Finish by clicking the “Write” button.
We are including a profile file (
folder to load a Digi
nected to an available USB port on your PC, start the X-CTU utility. Click the “Load”
button in the
Then click the “Write” button to write the settings to the Digi
User’s Manual
port the Digi
response showing the Modem Type (XB 24-B) and the firmware version. Click
Note that several USB serial ports could be listed. If you select a serial port without the
Digi
cation with modem … OK,” but the modem type will be unknown, and the firmware
version will be blank.
If you a get a message that X-CTU is unable to open the COM port, verify that you
selected the COM port with the “USB Serial Port,” then try unplugging the Digi
USB from the USB slot and plugging it back in. Now click “Test/Query” again.
the networking and I/O parameters for the Digi
coordinator.
match the parameters in the Dynamic C
library.
match the parameters in the Dynamic C
library.
Modem: XBEE XB24-ZB
Function Set: ZIGBEE COORDINATOR API (do not select other settings)
Version: the version of the firmware included with the version of Dynamic C you are using (should be
Networking
®
of the type 21…)
(D) CH - Operating Channel — this is the operating channel you could see when you ran the
AT_INTERACTIVE.C
ing the command ATCH <Enter>. This channel information cannot be changed from the X-CTU
utility.
(0123456789ABCDEF) ID - Extended Pan ID — set the new extended PAN ID that follows 0x to
match the
(1FFE) SC - Scan Channels - set the new value for the channels to scan, E, for example, to match
the new setting in the macro.
#define DEFAULT_CHANNELS 0x000E
XBee USB connected, the X-CTU response to “Test/Query.” will be “communi-
Profile
®
DEFAULT_EXTPANID
XBee USB is connected to and click “Test/Query.” You should see a
®
section, navigate to the
XBee USB with default settings. Once the Digi
sample program in the Dynamic C
XBee-USB ZB defaults.pro
macro.
LIB\Rabbit4000\XBee\XBEE_API.LIB
LIB\Rabbit4000\XBee\XBEE_API.LIB
.pro
®
file, and it will set all of the defaults.
XBee USB being used as the ZigBee
SAMPLES\XBEE
®
) in the
XBee USB.
Utilities/X-CTU
®
XBee USB is con-
folder by enter-
®
OK
XBee
.
105