101-1272 Rabbit Semiconductor, 101-1272 Datasheet - Page 20

• Manufacturer Part Number: 101-1272
• Description: KIT MESH NETWORK ADD-ON RCM4510W
• Manufacturer: Rabbit Semiconductor
• Type: Microprocessorr

Specifications of 101-1272

• Product: Modules
• Data Bus Width: 12 bit
• Processor Type: Rabbit 4000
• Sram: 512 KB
• Number Of I/os: 20
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: RCM4510W
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1158

2.3 Run a Sample Program
If you already have Dynamic C installed, you are now ready to test your programming
connections by running a sample program. Start Dynamic C by double-clicking on the
Dynamic C icon on your desktop or in your
You may have to select the COM port assigned to the USB programming cable on your
PC. In Dynamic C, select
“Communications” tab. Then check “Use USB to Serial Converter” in “Serial Options.”
Click
Find the file
open it with the
will open on your PC and will display a small square bouncing around in a box.
2.3.1 Troubleshooting
If you receive the message
assigned to the USB programming cable was identified and set up in Dynamic C as
described in the preceding section.
If you receive the message
may be connected to the wrong COM port, a connection may be faulty, or the target
system may not be powered up. First, check to see that the power LED on the Prototyping
Board is lit. If the LED is lit, check both ends of the programming cable to ensure that it is
firmly plugged into the PC and the programming header on the RCM4510W with the
marked (colored) edge of the programming cable towards pin 1 of the programming
header. Ensure that the module is firmly and correctly installed in its connectors on the
Prototyping Board.
If Dynamic C appears to compile the BIOS successfully, but you then receive a communi-
cation error message when you compile and load a sample program, it is possible that your
PC cannot handle the higher program-loading baud rate. Try changing the maximum
download rate to a slower baud rate as follows.
• Locate the
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the
Press
compiled successfully
14
Options > Project Options
Options > Project Options
<Ctrl-Y>
OK
to save the settings.
PONG.C
Serial Options
Serial Options
to force Dynamic C to recompile the BIOS. You should receive a
File
menu, then compile and run it by pressing
, which is in the Dynamic C
Options > Project Options
No Rabbit Processor Detected
Could Not Open Serial Port
message once this step is completed successfully.
dialog on the “Communications” tab in the Dynamic C
dialog on the “Communications” tab in the Dynamic C
menu. Select a slower Max download baud rate.
menu. Choose a lower debug baud rate.
Start
SAMPLES
menu.
, then select this COM port on the
folder. To run the program,
F9
, check that the COM port
, the programming cable
. The
RabbitCore RCM4500W
STDIO
window
Bios