101-1272 Rabbit Semiconductor, 101-1272 Datasheet - Page 42

• Manufacturer Part Number: 101-1272
• Description: KIT MESH NETWORK ADD-ON RCM4510W
• Manufacturer: Rabbit Semiconductor
• Type: Microprocessorr

Specifications of 101-1272

• Product: Modules
• Data Bus Width: 12 bit
• Processor Type: Rabbit 4000
• Sram: 512 KB
• Number Of I/os: 20
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: RCM4510W
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1158

4.2.2 Programming Port
The RCM4510W is programmed via the 10-pin header labeled J2. The programming port
uses the Rabbit 4000’s Serial Port A for communication. Dynamic C uses the programming
port to download and debug programs.
Serial Port A is also used for the following operations.
• Cold-boot the Rabbit 4000 on the RCM4510W after a reset.
• Fast copy designated portions of flash memory from one Rabbit-based board (the
Alternate Uses of the Programming Port
All three Serial Port A signals are available as
• a synchronous serial port
• an asynchronous serial port, with the clock line usable as a general CMOS I/O pin
The programming port may also be used as a serial port via the
programming cable.
In addition to Serial Port A, the Rabbit 4000 startup-mode (SMODE0, SMODE1),
STATUS, and reset pins are available on the programming port.
The two startup-mode pins determine what happens after a reset—the Rabbit 4000 is
either cold-booted or the program begins executing at address 0x0000.
The status pin is used by Dynamic C to determine whether a Rabbit microprocessor is
present. The status output has three different programmable functions:
1. It can be driven low on the first op code fetch cycle.
2. It can be driven low during an interrupt acknowledge cycle.
3. It can also serve as a general-purpose output once a program has been downloaded and
The reset pin is an external input that is used to reset the Rabbit 4000.
Refer to the
36
master) to another (the slave) using the Rabbit Cloning Board.
is running.
Rabbit 4000 Microprocessor User’s Manual
for more information.
DIAG
RabbitCore RCM4500W
connector on the