101-1272 Rabbit Semiconductor, 101-1272 Datasheet - Page 28

• Manufacturer Part Number: 101-1272
• Description: KIT MESH NETWORK ADD-ON RCM4510W
• Manufacturer: Rabbit Semiconductor
• Type: Microprocessorr

Specifications of 101-1272

• Product: Modules
• Data Bus Width: 12 bit
• Processor Type: Rabbit 4000
• Sram: 512 KB
• Number Of I/os: 20
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: RCM4510W
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 316-1158

•
22
IOCONFIG_SWITCHECHO.C
and F, which then transmit and then receive an ASCII string when switch S2 or S3 is
pressed. The echoed serial data are displayed in the Dynamic C
Note that the I/O lines that carry the Serial Port E and F signals are not the Rabbit 4000
defaults. The Serial Port E and F I/O lines are configured by calling the library function
serEFconfig()
Note that the
support this sample program is provided in the Dynamic C
SERIAL
Serial Port E is configured to use Parallel Port E bits PE6 and PE7. These signals are
available on the Prototyping Board's Module Extension Header (header J2).
Serial Port F is configured to use Parallel Port C bits PC2 and PC3. These signals are
available on the Prototyping Board's RS-232 connector (header J4).
Serial Port D is left in its default configuration, using Parallel Port C bits PC0 and PC1.
These signals are available on the Prototyping Board's RS-232 connector (header J4).
Serial Port D transmits and then receives an ASCII string with Serial Port F when
switch S3 is pressed.
To set up the Prototyping Board, you will need to tie TxC
and RxD together on the RS-232 header at J4 using the
jumpers supplied in the Development Kit; you will also
tie TxE (PE6) and RxE (PE7) together with a soldered
wire or with a wire jumper if you have soldered in the
IDC header supplied with the accessory parts in the
Development Kit.
Once you have compiled and run this program, press and
release switches S2 or S3 on the Prototyping Board. The data echoed between the serial
ports will be displayed in the
folder.
RCM45_29MHZ_IOCONFIG.LIB
that was generated by the Rabbit 4000
—This program demonstrates how to set up Serial Ports E
STDIO
window.
library generated by
IOCONFIG.EXE
SAMPLES\RCM4500W\
STDIO
RabbitCore RCM4500W
IOCONFIG.EXE
window.
utility program.
to