ELCSOFT Eaton / Control Automation, ELCSOFT Datasheet - Page 124

• Manufacturer Part Number: ELCSOFT
• Description: ACCESSORY; ELC PROGRAMMING SOFTWARE FOR ELC CONTROLLERS
• Manufacturer: Eaton / Control Automation

7 Communication
4.
＊footnote 1:
7-4
Before executing “write to ELC”, make sure that the ELC is in STOP mode, or if ELC is
in RUN mode, ELCSoft will then send out a warning message of “Cannot perform this
operation in run mode” “Do you wish to continues if this instruction will affect the state of
the connect ELC ?”(as shown below). If choose "Yes", ELCSoft will stop ELC first and
write program into ELC. After completing, it will inquire you to return to RUN status or
not.
There are two methods to write to ELC: write whole data and partial data. (footnote 1)
a. Whole data: write whole data to the designated ELC. (as shown below)
b. Partial data: you can set step range to write to ELC. If you select step range
without setting start and end step. It will write the data from 0 step to the first end
to ELC. (as shown below)