ELCSOFT Eaton / Control Automation, ELCSOFT Datasheet - Page 65

• Manufacturer Part Number: ELCSOFT
• Description: ACCESSORY; ELC PROGRAMMING SOFTWARE FOR ELC CONTROLLERS
• Manufacturer: Eaton / Control Automation

■
1.
2.
If you want to edit the comments at the same time when input an instruction by using
keyboard, you can click the “Prompt to Edit Device Comment(H)” under the “Options” menu.
Then, the “Comment” dialog box (see the figure below) will appear for you to enter and edit
the corresponding comments after an instruction is input correctly.
Keyboard Operation
Place the editing block at the start of the document, and type LD M10 (or A M10) by
Type OUT Y0 (or O Y0) and press Enter key on the keyboard. Then, type END and
using the keyboard. Then, press the Enter key on the keyboard, or click the button
“OK” to complete the setting.
press Enter key on the keyboard. Finally, click the icon
ladder diagram.
4 Ladder Diagram Mode
to compiler the completed
4-7