ELCSOFT Eaton / Control Automation, ELCSOFT Datasheet - Page 79

• Manufacturer Part Number: ELCSOFT
• Description: ACCESSORY; ELC PROGRAMMING SOFTWARE FOR ELC CONTROLLERS
• Manufacturer: Eaton / Control Automation

●
This function is used to compile current ELC programs. If the you complete the editing of
the ladder diagram in the ladder diagram mode, performing this function will check whether
the ladder diagram is valid or not, and if the conversion is correct, the ladder diagram could
thus be converted to the instruction program or the SFC diagram. And at the same time,
the program memory addresses (numbers of steps) for each editing block will appear on
the left-hand side of the start of the ladder diagram. However, if an error occurred, a ladder
diagram error message dialog box will appear, display the error code and point out the
exact erroneous addresses after the compiler action is completed (please refer to the ELC
user manual).
If the program editing is completed in the instruction mode when performing this function, it
will start to check whether the conversion is correct or not, and if the conversion is correct,
the instruction program will be converted to the ladder diagram. However, if error occurred,
an error message dialog box will appear, display the error code and point out the exact
erroneous steps after the compiler action is completed (Please refer to the ELC User
Manual).
■
Compiler
Method 1: Click “Edit” > “Insert Block”
Method 2: Use keyboard shortcuts by pressing keys (Ctrl) + (Ins)
Method 3: Right click the mouse and select the “Insert Block” command in the
Insert Block (Before inserting the selected block, perform “Copy Block” action first)
pop-up menu.
4 Ladder Diagram Mode
4-21