STM8S005K6 STMicroelectronics, STM8S005K6 Datasheet - Page 49

• Manufacturer Part Number: STM8S005K6
• Description: Value line, 16 MHz STM8S 8-bit MCU, 32 Kbytes Flash, data EEPROM
• Manufacturer: STMicroelectronics

Specifications of STM8S005K6

• Program Memory: 32 Kbytes Flash; data retention 20 years at 55 °C after 100 cycles
• Data Memory: 128 bytes of true data EEPROM; endurance up to 100 k write/erase cycles
• Ram: 2 Kbytes
• Advanced Control Timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization

STM8S005K6 STM8S005C6
9
9.1
9.1.1
9.1.2
9.1.3
9.1.4
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100 % of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on characterization,
the minimum and maximum values refer to sample tests and represent the mean value plus
or minus three times the standard deviation (mean ± 3 Σ).
Typical values
Unless otherwise specified, typical data are based on T
only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ± 2 Σ).
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are not
tested.
Typical current consumption
For typical current consumption measurements, V
in the configuration shown in the following figure.
Figure 6: Supply current measurement conditions
5 V or 3.3 V
DocID022186 Rev 2
A
DD
V
V
V
V
V
V
DD
SSIO
DDA
DDIO
SS
SSA
, V
DDIO
A
A
SS
= 25 °C and T
= 25 °C, V
.
and V
DDA
Electrical characteristics
DD
are connected together
= 5 V. They are given
A
= T
Amax
(given by
49/103