STM8S005K6 STMicroelectronics, STM8S005K6 Datasheet - Page 52

• Manufacturer Part Number: STM8S005K6
• Description: Value line, 16 MHz STM8S 8-bit MCU, 32 Kbytes Flash, data EEPROM
• Manufacturer: STMicroelectronics

Specifications of STM8S005K6

• Program Memory: 32 Kbytes Flash; data retention 20 years at 55 °C after 100 cycles
• Data Memory: 128 bytes of true data EEPROM; endurance up to 100 k write/erase cycles
• Ram: 2 Kbytes
• Advanced Control Timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization

Electrical characteristics
9.3
52/103
Operating conditions
The device must be used in operating conditions that respect the parameters in the table
below. In addition, full account must be taken of all physical capacitor characteristics and
tolerances.
Symbol
Symbol
I
ΣI
(1)
(2)
connected to the external supply.
(3)
around the package between the V
(4)
If V
I
by V
corresponding V
(5)
characteristics.
(6)
absolute sum of the positive and negative injected currents (instantaneous values). These
results are based on characterization with ΣI
port pins of the device.
T
T
INJ(PIN)
INJ(PIN)
STG
J
INJ(PIN)
Negative injection disturbs the analog performance of the device. See note in
Data based on characterization results, not tested in production.
All power (V
I/O pins used simultaneously for high current source/sink must be uniformly spaced
I
When several inputs are submitted to a current injection, the maximum ΣI
INJ(PIN)
IN
IN
maximum cannot be respected, the injection current must be limited externally to the
<V
value. A positive injection is induced by V
(4) (5)
SS
(4)
must never be exceeded. This is implicitly insured if V
. For true open-drain pads, there is no positive injection current, and the
DD
Ratings
Injected current on NRST pin
Injected current on OSCIN pin
Injected current on any other pin
Total injected current (sum of all I/O and control pins)
IN
, V
Ratings
maximum must always be respected
Storage temperature range
Maximum junction temperature
DDIO
, V
Table 16: Thermal characteristics
DDA
DocID022186 Rev 2
) and ground (V
DDIO
/V
SSIO
INJ(PIN)
pins.
SS
IN
(6)
, V
>V
SSIO
maximum current injection on four I/O
DD
while a negative injection is induced
, V
SSA
STM8S005K6 STM8S005C6
) pins must always be
Value
-65 to 150
150
IN
maximum is respected.
(6)
Max.
±4
±4
±4
±20
(1)
INJ(PIN)
I2C interface
Unit
°C
Unit
is the