mc68hc908gr8b Freescale Semiconductor, Inc, mc68hc908gr8b Datasheet - Page 151

• Manufacturer Part Number: mc68hc908gr8b
• Description: M68hc08 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

PE — Receiver Parity Error Bit
13.8.5 SCI Status Register 2
SCI status register 2 contains flags to signal the following conditions:
BKF — Break Flag Bit
RPF — Reception in Progress Flag Bit
Freescale Semiconductor
This clearable, read-only bit is set when the SCI detects a parity error in incoming data. PE generates
an SCI error CPU interrupt request if the PEIE bit in SCC3 is also set. Clear the PE bit by reading SCS1
with PE set and then reading the SCDR. Reset clears the PE bit.
•
•
This clearable, read-only bit is set when the SCI detects a break character on the PTE1/RxD pin. In
SCS1, the FE and SCRF bits are also set. In 9-bit character transmissions, the R8 bit in SCC3 is
cleared. BKF does not generate a CPU interrupt request. Clear BKF by reading SCS2 with BKF set
and then reading the SCDR. Once cleared, BKF can become set again only after 1s again appear on
the PTE1/RxD pin followed by another break character. Reset clears the BKF bit.
This read-only bit is set when the receiver detects a 0 during the RT1 time period of the start bit search.
RPF does not generate an interrupt request. RPF is reset after the receiver detects false start bits
(usually from noise or a baud rate mismatch) or when the receiver detects an idle character. Polling
RPF before disabling the SCI module or entering stop mode can show whether a reception is in
progress.
1 = Parity error detected
0 = No parity error detected
1 = Break character detected
0 = No break character detected
1 = Reception in progress
0 = No reception in progress
Break character detected
Incoming data
Address:
Reset:
Read:
Write:
$0017
Bit 7
0
Figure 13-15. SCI Status Register 2 (SCS2)
= Unimplemented
6
0
MC68HC908GR8B Data Sheet, Rev. 3.0
5
0
4
0
3
0
2
0
BKF
1
0
Bit 0
RPF
0
I/O Registers
151