m5m51016btp Renesas Electronics Corporation., m5m51016btp Datasheet - Page 48

• Manufacturer Part Number: m5m51016btp
• Description: Renesas 16-bit Single-chip Microcomputer M16c Family / M16c/20 Series
• Manufacturer: Renesas Electronics Corporation.

M30245 Group
Rev.2.00 Oct 16, 2006
REJ09B0340-0200
2.3 Clock-Synchronous Serial I/O
2.3.1 Overview
Clock-synchronous serial I/O carries out 8-bit data communications in synchronization with the clock. The
following is an overview of the clock-synchronous serial I/O.
(1) Transmission/reception format
(2) Transfer rate
(3) Error detection
(4) How to deal with an error
(5) Function selection
• When receiving data, read an error flag and reception data simultaneously to determine which error
• To transmit data again due to an error such as staggered serial clock caused by noise, set the UARTi
8-bit data
If the internal clock is selected as the transfer clock, the divide-by-2 frequency, resulting from the bit
rate generator division, becomes the transfer rate. The bit rate generator count source can be se-
lected from the following: f
clock by 1, 8, and 32 respectively.
Furthermore, if an external clock is selected as the transfer clock, the clock frequency input to the CLK
pin becomes the transfer rate.
Only overrun errors can be detected. Overrun error is an error that occurs if the serial interface starts
receiving the next data item before reading the contents of the UARTi receive buffer register and
receives the 7th bit of the next data.
To initialize the UARTi receive buffer register
To set the UARTi transmit buffer register again
For clock-synchronous serial I/O, the following functions can be selected:
(a) CTS/RTS function
has occurred. If the data read is erroneous, initialize the error flag and the UARTi receive buffer
register, then receive the data again.
1. Set the receive enable bit to “0” (disable reception).
2. Set the serial I/O mode select bit to “000
3. Set the serial I/O mode select bit.
4. Set the receive enable bit to “1” again (enable reception).
transmit buffer register again, then transmit the data again.
1. Set the serial I/O mode select bits to “000
2. Set the serial I/O mode select bits again.
3. Set the transmit enable bit to “1” (enable transmission), then set transmission data in the UARTi
In the CTS function, an external IC can start transmission/reception by inputting an “L” level to the
CTS pin. The CTS pin input level is detected when transmission/reception starts. Therefore, if the
level is set to “H” during transmission/reception, it will stop from the next data.
The RTS function informs an external IC that RTS is reception-ready and has changed to “L”. RTS
goes back to “H” at the first falling edge of the transfer clock.
_______
_______ _______
transmit buffer register.
_______
_______
page 39 of 354
_______
1
, f
8
, and f
32
. Clocks f
2
” (invalid serial I/O).
2
” (invalidate serial I/O).
_______
1
, f
8
, and f
32
are derived by dividing the CPU’s main
2. Clock-Synchronous Serial I/O
_______