ATTINY20-EK1 Atmel, ATTINY20-EK1 Datasheet - Page 17

• Manufacturer Part Number: ATTINY20-EK1
• Description: KIT EVAL TOUCH ATTINY20
• Manufacturer: Atmel

Specifications of ATTINY20-EK1

• Sensor Type: *
• Sensing Range: *
• Interface: *
• Sensitivity: *
• Voltage - Supply: *
• Embedded: *
• Utilized Ic / Part: *
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Core Sub-architecture: TinyAVR
• Kit Contents: Board
• Svhc: No SVHC (15-Dec-2010)
• Mcu Supported Families: ATtiny20
• Tool / Board Applications: Microcontroller
• Rohs Compliant: Yes
• Tool Type: Development Kit
• Cpu Core: AVR 8
• Data Bus Width: 8 bit
• Processor To Be Evaluated: ATtiny20
• Interface Type: Touch
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

5.3
8235B–AVR–04/11
I/O Memory
The I/O space definition of the ATtiny20 is shown in
All ATtiny20 I/Os and peripherals are placed in the I/O space. All I/O locations may be accessed
using the LD and ST instructions, enabling data transfer between the 16 general purpose work-
ing registers and the I/O space. I/O Registers within the address range 0x00 - 0x1F are directly
bit-accessible using the SBI and CBI instructions. In these registers, the value of single bits can
be checked by using the SBIS and SBIC instructions. See document “AVR Instruction Set” and
section
commands IN and OUT, the I/O addresses 0x00 - 0x3F must be used.
For compatibility with future devices, reserved bits should be written to zero if accessed.
Reserved I/O memory addresses should never be written.
Some of the status flags are cleared by writing a logical one to them. Note that CBI and SBI
instructions will only operate on the specified bit, and can therefore be used on registers contain-
ing such status flags. The CBI and SBI instructions work on registers in the address range 0x00
to 0x1F, only.
The I/O and Peripherals Control Registers are explained in later sections.
“Instruction Set Summary” on page 210
for more details. When using the I/O specific
“Register Summary” on page
ATtiny20
208.
17