MC9S12E64CFUE Freescale Semiconductor, MC9S12E64CFUE Datasheet - Page 164

• Manufacturer Part Number: MC9S12E64CFUE
• Description: IC MCU 64K FLASH 25MHZ 80-QFP
• Manufacturer: Freescale Semiconductor
• Series: HCS12r

Specifications of MC9S12E64CFUE

• Core Processor: HCS12
• Core Size: 16-Bit
• Speed: 25MHz
• Connectivity: EBI/EMI, I²C, SCI, SPI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 60
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.35 V ~ 2.75 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 80-QFP
• Package: 80PQFP
• Family Name: HCS12
• Maximum Speed: 25 MHz
• Operating Supply Voltage: 2.5|3.3|5 V
• Data Bus Width: 16 Bit
• Number Of Programmable I/os: 60
• Interface Type: SCI/SPI
• On-chip Adc: 16-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 12
• Processor Series: S12E
• Core: HCS12
• Data Ram Size: 4 KB
• Maximum Clock Frequency: 25 MHz
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: EWHCS12
• Minimum Operating Temperature: - 40 C
• Controller Family/series: HCS12/S12X
• No. Of I/o's: 58
• Ram Memory Size: 4KB
• Cpu Speed: 25MHz
• No. Of Timers: 4
• Embedded Interface Type: I2C, SCI, SPI
• Rohs Compliant: Yes
• For Use With: M68EVB912E128 - BOARD EVAL FOR MC9S12E128/64
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Chapter 3 Port Integration Module (PIM9E128V1)
A valid edge on an input is detected if 4 consecutive samples of a passive level are followed by 4
consecutive samples of an active level directly or indirectly
The filters are continuously clocked by the bus clock in RUN and WAIT mode. In STOP mode the clock
is generated by a single RC oscillator in the port integration module. To maximize current saving the RC
oscillator runs only if the following condition is true on any pin:
Sample count <= 4 and port interrupt enabled (PIE=1) and port interrupt flag not set (PIF=0).
3.6.2
3.6.3
All clocks are stopped in STOP mode. The port integration module has asynchronous paths on port AD to
generate wake-up interrupts from stop mode. For other sources of external interrupts refer to the respective
block description chapters.
164
Interrupt Sources
Operation in Stop Mode
Vector addresses and their relative interrupt priority are determined at the
MCU level.
Interrupt
Port AD
Source
Table 3-39. Port Integration Module Interrupt Sources
PIFAD[15:0]
Interrupt
MC9S12E128 Data Sheet, Rev. 1.07
Figure 3-52. Pulse Illustration
Flag
NOTE
t
pulse
PIEAD[15:0]
Enable
Local
Global (CCR)
Mask
I Bit
Freescale Semiconductor