HD64F3687GFPV Renesas Electronics America, HD64F3687GFPV Datasheet - Page 75

• Manufacturer Part Number: HD64F3687GFPV
• Description: IC H8 MCU FLASH 56K 64LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3687GFPV

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, SCI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 45
• Program Memory Size: 56KB (56K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-LQFP
• Package: 64LQFP
• Family Name: H8
• Maximum Speed: 20 MHz
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 45
• Interface Type: I2C/SCI
• On-chip Adc: 8-chx10-bit
• Number Of Timers: 3
• For Use With: R0K436079S000BE - KIT DEV FOR H8/36079 W/COMPILER
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

2.8
2.8.1
The address space of this LSI includes empty areas in addition to the ROM, RAM, and on-chip
I/O registers areas available to the user. When data is transferred from CPU to empty areas, the
transferred data will be lost. This action may also cause the CPU to malfunction. When data is
transferred from an empty area to CPU, the contents of the data cannot be guaranteed.
2.8.2
EEPMOV is a block-transfer instruction and transfers the byte size of data indicated by R4L,
which starts from the address indicated by R5, to the address indicated by R6. Set R4L and R6 so
that the end address of the destination address (value of R6 R4L) does not exceed H'FFFF (the
value of R6 must not change from H'FFFF to H'0000 during execution).
2.8.3
The BSET, BCLR, BNOT, BST, and BIST instructions read data from the specified address in
byte units, manipulate the data of the target bit, and write data to the same address again in byte
units. Special care is required when using these instructions in cases where two registers are
assigned to the same address, or when a bit is directly manipulated for a port or a register
containing a write-only bit, because this may rewrite data of a bit other than the bit to be
manipulated.
Usage Notes
Notes on Data Access to Empty Areas
EEPMOV Instruction
Bit-Manipulation Instruction
Program halt state
Reset
occurs
Reset state
Figure 2.12 State Transitions
Reset
occurs
SLEEP instruction executed
Reset cleared
Reset occurs
Interrupt
source
Exception-handling state
Program execution state
Rev.5.00 Nov. 02, 2005 Page 41 of 500
Interrupt
source
Exception-
handling
complete
REJ09B0027-0500
Section 2 CPU