D12363VF33V Renesas Electronics America, D12363VF33V Datasheet - Page 824

• Manufacturer Part Number: D12363VF33V
• Description: IC H8S/2363 MCU ROMLESS 128QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of D12363VF33V

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 84
• Program Memory Type: ROMless
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 128-QFP
• For Use With: YR0K42378FC000BA - KIT EVAL FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Section 20 Flash Memory (0.18-μm F-ZTAT Version)
6. After erasure completes, clear FKEY and specify software protection.
20.4.3
This LSI has user boot mode which is initiated with different mode pin settings than those in user
program mode or boot mode. User boot mode is a user-arbitrary boot mode, unlike boot mode that
uses the on-chip SCI.
Only the user MAT can be programmed/erased in user boot mode. Programming/erasing of the
user boot MAT is only enabled in boot mode or programmer mode.
(1)
For the mode pin settings to start up user boot mode, see table 20.5.
When the reset start is executed in user boot mode, the built-in check routine runs. The user MAT
and user boot MAT states are checked by this check routine.
While the check routine is running, NMI and all other interrupts cannot be accepted.
Next, processing starts from the execution start address of the reset vector in the user boot MAT.
At this point, H'AA is set to FMATS because the execution MAT is the user boot MAT.
(2)
For programming the user MAT in user boot mode, additional processing made by setting FMATS
are required: switching from user-boot-MAT selection state to user-MAT selection state, and
switching back to user-boot-MAT selection state after programming completes.
Figure 20.13 shows the procedure for programming the user MAT in user boot mode.
Rev.6.00 Mar. 18, 2009 Page 764 of 980
REJ09B0050-0600
If this LSI is restarted by a power-on reset immediately after user MAT erasure has completed,
secure a reset period (period of RES = 0) that is at least as long as normal 100 μs.
User Boot Mode Initiation
User MAT Programming in User Boot Mode
User Boot Mode