TDA5250 Infineon Technologies, TDA5250 Datasheet - Page 46

• Manufacturer Part Number: TDA5250
• Description: TX/RX ASK/FSK 868-870MHZ 38TSSOP
• Manufacturer: Infineon Technologies
• Type: Transceiverr

Specifications of TDA5250

• Package / Case: 38-TSSOP
• Frequency: 868MHz
• Data Rate - Maximum: 64kbps
• Modulation Or Protocol: ASK, FSK
• Applications: RKE, Remote Control Systems
• Power - Output: 9dBm
• Sensitivity: -109dBm
• Voltage - Supply: 2.1 V ~ 5.5 V
• Current - Receiving: 9mA
• Current - Transmitting: 12mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Operating Frequency: 870 MHz
• Operating Supply Voltage: 2.5 V, 3.3 V, 5 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Product Depth (mm): 4.4mm
• Product Length (mm): 9.7mm
• Operating Supply Voltage (min): 2.1V
• Operating Supply Voltage (max): 5.5V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Compliant
• Other names: SP000012956; TDA5250; TDA5250INTR; TDA5250XT; TDA5250XT

Figure 3-8
C4, L2 and C3||C2 are the main matching components which are used to transform the 50 Ohm
load at the SMA-RF-connector to a higher impedance at the PA-output (240Ohm@3V). L1 can be
used for finetuning of the resonance frequency but should not be too low in order to keep its loss
low.
The transformed impedance of 240Ohm+j0 at the PA-output-pin can be verified with a network
analyzer using this measurement procedure:
1. Calibrate your network analyzer.
2. Connect a short, low-loss 50 Ohm cable to your network analyzer with an open end on one side.
3. Use the „Port Extension“ feature of your network analyzer to shift the reference plane of your
4. Connect the center-conductor of the cable to the solder pad of the pin „PA“ of the IC. The shield
5. Screw a 50Ohm-dummy-load on the RF-I/O-SMA-connector
6. The TDA5250 has to be in ASK-TX-Mode, Data-Input=LOW.
7. Be sure that your network analyzer is AC-coupled and turn on the power supply of the IC.
8. Measure the S-parameter
Data Sheet
Semirigid cable works best.
network analyzer to the open end of the cable.
has to be grounded. Very short connections must be used. Do not remove the IC or any part of
the matching-components!
Power output and collector current vs. frequency
46
TDA5250 D2
Version 1.7
Application
pout_vs_frequ.wmf
2007-02-26