XRT75R03IVTR Exar Corporation, XRT75R03IVTR Datasheet - Page 62

• Manufacturer Part Number: XRT75R03IVTR
• Description: IC LIU E3/DS3/STS-1 3CH 128LQFP
• Manufacturer: Exar Corporation

Specifications of XRT75R03IVTR

• Lead Free Status / RoHS Status: Contains lead / RoHS Compliant

XRT75R03
REV. 1.0.8
N
UMBER
B
5
4
3
2
IT
RxON Ch 1
RxON Ch 0
TxON Ch 2
Reserved
N
AME
THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
T
R/W
R/W
R/W
R/O
YPE
0
0
0
0
D
V
EFAULT
ALUE
Receiver Section ON - Channel 1
This READ/WRITE bit-field is used to either turn on or turn off the
Receive Section of Channel 1. If the user turns on the Receive Sec-
tion, then Channel 1 will begin to receive the incoming DS3, E3 or
STS-1 data-stream via the RTIP_1 and RRING_1 input pins.
Conversely, if the user turns off the Receive Section, then the entire
Receive Section (e.g., AGC and Receive Equalizer Block, Clock
Recovery PLL, etc) will be powered down.
0 - Shuts off the Receive Section of Channel 1.
1 - Turns on the Receive Section of Channel 1.
Receiver Section ON - Channel 0
This READ/WRITE bit-field is used to either turn on or turn off the
Receive Section of Channel 0. If the user turns on the Receive Sec-
tion, then Channel 0 will begin to receive the incoming DS3, E3 or
STS-1 data-stream via the RTIP_0 and RRING_0 input pins.
Conversely, if the user turns off the Receive Section, then the entire
Receive Section (e.g., AGC and Receive Equalizer Block, Clock
Recovery PLL, etc) will be powered down.
0 - Shuts off the Receive Section of Channel 0.
1 - Turns on the Receive Section of Channel 0.
Transmit Driver ON - Channel 2
This READ/WRITE bit-field is used to either turn on or turn off the
Transmit Driver associated with Channel 2. If the user turns on the
Transmit Driver, then Channel 2 will begin to transmit DS3, E3 or
STS-1 pulses on the line via the TTIP_2 and TRING_ 2 output pins.
Conversely, if the user turns off the Transmit Driver, then the TTIP_2
and TRING_2 output pins will be tri-stated.
0 - Shuts off the Transmit Driver associated with Channel 2 and tri-
states the TTIP_2 and TRING_ 2 output pins.
1 - Turns on or enables the Transmit Driver associated with Channel
2.
N
OTE
: If the user wishes to exercise software control over the state
59
of the Transmit Driver associated with Channel 2, then it is
imperative that the user pull the TxON_2 (pin 125) to a logic
"High" level.
D
ESCRIPTION
xr
xr
xr
xr