P89LPC912FDH NXP Semiconductors, P89LPC912FDH Datasheet - Page 47

• Manufacturer Part Number: P89LPC912FDH
• Description: MCU 8BIT 80C51 1K FLASH, TSSOP14
• Manufacturer: NXP Semiconductors

Specifications of P89LPC912FDH

• Controller Family/series: (8051) 8052
• Core Size: 8bit
• No. Of I/o's: 12
• Program Memory Size: 1KB
• Ram Memory Size: 128Byte
• Cpu Speed: 18MHz
• Oscillator Type: External, Internal
• No. Of Timers: 4
• No. Of: RoHS Compliant

NXP Semiconductors
P89LPC912_913_914_5
Product data sheet
Fig 23. Watchdog timer in Watchdog mode (WDTE = ‘1’)
(1) Watchdog reset can also be caused by an invalid feed sequence, or by writing to WDCON not immediately followed by a
feed sequence.
watchdog
oscillator
MOV WFEED1, #0A5H
MOV WFEED2, #05AH
PCLK
8.25 Watchdog timer
In order to use the Keypad Interrupt as an original KBI function like in 87LPC76x series,
the user needs to set KBPATN = 0FFH and PATN_SEL = 1 (not equal), then any key
connected to Port 0 which is enabled by the KBMASK register will cause the hardware to
set KBIF and generate an interrupt if it has been enabled. The interrupt may be used to
wake up the CPU from Idle or Power-down modes. This feature is particularly useful in
handheld, battery-powered systems that need to carefully manage power consumption
yet also need to be convenient to use.
In order to set the flag and cause an interrupt, the pattern on Port 0 must be held longer
than 6 CCLKs.
The watchdog timer causes a system reset when it underflows as a result of a failure to
feed the timer prior to the timer reaching its terminal count. It consists of a programmable
12-bit prescaler, and an 8-bit down counter. The down counter is decremented by a tap
taken from the prescaler. The clock source for the prescaler is either the PCLK or the
nominal 400 kHz watchdog oscillator. The watchdog timer can only be reset by a
power-on reset. When the watchdog feature is disabled, it can be used as an interval timer
and may generate an interrupt.
Feeding the watchdog requires a two-byte sequence. If PCLK is selected as the watchdog
clock and the CPU is powered-down, the watchdog is disabled. The watchdog timer has a
time-out period that ranges from a few s to a few seconds. Please refer to the
P89LPC912/913/914 User manual for more details.
WDCON (A7H)
32
PRE2
PRESCALER
Rev. 05 — 28 September 2007
PRE1
PRE0
Figure 23
SHADOW REGISTER
8-bit microcontrollers with two-clock 80C51 core
-
shows the watchdog timer in Watchdog mode.
-
P89LPC912/913/914
8-BIT DOWN
WDL (C1H)
COUNTER
WDRUN
WDTOF
WDCLK
© NXP B.V. 2007. All rights reserved.
002aaa905
reset
(1)
47 of 66